Cisco Systems 600W quick start Power Up the Equipment, Obtaining Documentation

5Power Up the Equipment

Step 1 If you are using the redundant-with-reboot configuration (not recommended), power up the switch by connecting the AC power cord of the hub or switch to an AC power outlet.

Note If you use the redundant-with-reboot configuration, it is important to power up the hub or switch before powering up the Cisco RPS to ensure correct operation. If the Cisco RPS powers up first, the LEDs might not indicate the actual state.

Step 2 Plug the other end of the Cisco RPS AC power cable into an AC power outlet.

Step 3 Power up the Cisco RPS. There is a separate power switch for each AC input power source. Make sure that the power switch is on for each AC power source used. (See Figure 17.)

Figure 17 Powering Up the Cisco RPS

Power switch

29091

The Cisco RPS provides power in 10 to 15 seconds. The Cisco RPS is working properly when all its front-panel LEDs are solid green. If the external device does not power up, refer to troubleshooting section of the Cisco Redundant Power System Hardware Installation Guide on Cisco.com.

6Obtaining Documentation

Cisco provides several ways to obtain documentation, technical assistance, and other technical resources. These sections explain how to obtain technical information from Cisco Systems.

Cisco.com

You can access the most current Cisco documentation on the World Wide Web at this URL:

http://www.cisco.com/univercd/home/home.htm

You can access the Cisco website at this URL:

http://www.cisco.com

International Cisco websites can be accessed from this URL:

http://www.cisco.com/public/countries_languages.shtml

14