Cisco Systems TES301 manual Connecting the Home Gateway

Page 37

Connecting the Home Gateway

7Connect the included power adapter to the TES301 power port, and then plug the power adapter into an electrical outlet.

Note: The power adapter that shipped with your device may differ from the illustration below.

8Use the power switch on the back panel to power on the TES301. The power LED on the front panel will light up as soon as the device powers on. The LCD will light up with a message that the device is booting up.

9Once the device boots up, use the LCD menu to view the Internet status to verify that the gateway is connected to the Internet as follows:

a Wave your hand over the LCD.

b Tap the up or down arrows repeatedly until the Internet Status icon is highlighted.

4038767 Rev A

17

Image 37

Contents Page Page Please Read Publication Disclaimer Trademark AcknowledgmentsCopyright Mitteilung für CATV-Techniker Aviso a los instaladores de sistemas Catv Contents Introducing the TES301 IP Managed Services Home Gateway Managing Digital Media Page Ground the Product Power Source WarningProtect the Product from Lightning Verify the Power Source from the On/Off Power LightProtect the Product When Moving It Check Product SafetyTelephone Equipment Notice Declaration of Conformity United States FCC ComplianceCanada EMI Regulation RF Exposure StatementsCanada CE Compliance National Restrictions Antennas Introduction About This GuidePurpose AudiencePage This Chapter ChapterHighlights Benefits and FeaturesSimplified Connected Home High-Speed Wireless Interfaces Personal Content Sharing and StoragePhone Services Application EnvironmentManagement and Troubleshooting Whats on the Top Panel? Introducing the TES301 IP Managed Services Home Gateway Whats on the Back Panel? Whats on the Side Panel? Whats on the Bottom Panel Page Installing the Home Gateway Mounting the TES301 Horizontally Mounting the Home GatewayMounting the TES301 Vertically Mounting the Home Gateway Installing the Home Gateway Connecting the Home Gateway Installing the Home Gateway Connecting the Home Gateway Installing the Home Gateway Configuration and Operation TES301 Logging into the Home Gateway Dashboard Pptp InternetInternet Configuration and Operation of the TES301 Internet Configuration and Operation of the TES301 Internet SIP VoIP SettingsVoIP Settings Configuration and Operation of the TES301 Service Configuration and Operation of the TES301 Voice Configuration and Operation of the TES301 Advanced Configuration and Operation of the TES301 VoIP Settings Call Log VoIP Settings Wi-Fi Wi-Fi Connect Devices Wi-Fi Home Address Configure the Dlna Settings Advanced Settings Managing Digital Media Using the Media Controller Using the Media Controller Managing Digital Media Using the Media Server Managing Digital Media Using the Media Server Page Using the LCD Get Familiar with the LCD Menus and Pages Internet Phone Phone Turn Wi-Fi Off or On Wi-Fi Before you proceed Initiate Wi-Fi Protection SetupWi-Fi Using the LCD Connection Settings Review Your Emergency 911 Address Perform Factory Reset Select Language Settings View Network Information Select LCD Display OrientationSettings Use Network Tools Reboot View Router Information View System Event Log Set Up Time of Day ParametersUsing the LCD App Store