Cisco Systems TES301 manual Initiate Wi-Fi Protection Setup, Before you proceed

Chapter 5 Using the LCD

4Tap the right arrow. A confirmation request appears.

5Tap the right arrow again to accept the change or tap the left arrow to cancel the request.

6Tap the left arrow to exit the SSID details page.

Initiate Wi-Fi Protection Setup

Complete the following steps to initiate Wi-Fi Protection Setup.

Before you proceed:

At least one SSID must already be set up. Go to the Wi-Fi(on page 40) section to setup an SSID.

Wi-Fi must be turned on for the SSID you are managing. Go to Turn Wi-Fi Off or On (on page 60) if Wi-Fi is not already turned on.

1From the Wi-Fi Network Status page, tap the down or up arrow keys to highlight the SSID you wish to manage.

62 4038767 Rev A