Billion Electric Company 400G manual Rear Ports, Antenna, 1X 4X RJ-45 connector

Page 8

Billion 400G Router

The Rear Ports

5




									4
1			2			3			4			6			7
1			2			3						6			7

The Ethernet Port # 4 can be used as a console port. You need a special console tool which already includes in the package to connect with LAN port 4 and PC’s RS-232 port (9-pin serial port).

Port

1Antenna

2ADSL

LAN

31X — 4X (RJ-45 connector)

4WPS

5RESET

6	Power

7	Power Switch

Meaning

Connect the detachable antenna to this port.

Use the supplied RJ-11 (“telephone”) cable to connect this port to the ADSL/telephone wall jack.

To connect your router to a PC or an office/home network of 10Mbps or 100Mbps use a UTP Ethernet cable (Cat-5 or Cat-5e) and connect to one of the LAN ports.

Caution: Port 4 can be either a LAN or a Console port at any time but not simultaneously.

Press the WPS button to trigger Wi-Fi Protected Setup function.

When the router is turned on the reset button is used to: Reset the router: press for 1-3 seconds.

Restore factory default settings: press for 6 – 8 seconds, and

power cycle the router: (useful if you cannot login to the router or have forgotten your Username/Password.)

Caution: After pressing the RESET button for 6 - 8 seconds, be sure you power cycle the device.

If the RESET button is pressed for more than 10 seconds, the device will need to be power cycled before normal operation can be resumed.

Connect the supplied power adapter to this jack.

Power ON/OFF switch

5

Chapter 2: Installing the router

Image 8

Contents Page Table of Contents Table of Contents Features Introduction to your Router Dynamic Host Configuration Protocol Dhcp Client and Server Firmware Upgradeable Virtual Server port forwarding Rich Packet FilteringImportant note for using this router Package ContentsPower LAN Port 1X Wireless MailFront LEDs InternetAntenna 1X 4X RJ-45 connectorRear Ports Cabling Basic Installation Connecting Your Router Double-clickLocal Area Connection. See Figure Select Internet Protocol TCP/IP and click Properties. SeeConfiguring PCs in Windows Configuring PC in Windows 95/98/ME Then select the DNS Configuration tab. See FigureGo to Start / Settings / Control Panel. In the Control Panel Select TCP/IP Protocol and click Properties. See FigureFactory Default Settings Information from your ISP PPPoAConfiguring with your Web Browser 14 User name & Password Prompt WindowQuick Start Configuration StatusARP Table StatusAdsl Status Dhcp Table Routing TableLeased Table Routing TableEmail Status NAT SessionsUPnP Portmap Event Log Error LogDiagnostic Quick Start Billion 400G Router Billion 400G Router Bridge Interface ConfigurationLAN Local Area Network Primary IP Address EthernetIP Alias → Active PC in LAN Ethernet Client Filter Default setting is set DisableEthernet Client Filter Wireless ParametersWireless Distribution System WDS Wireless Security WPA-PSK / WPA2-PSK / WEPWEP Associated Wireless Clients Wireless Client / MAC Address FilterWireless Client Filter Default setting is set to Disable Port Setting WPSDhcp Server Connection WAN Wide Area NetworkWAN Profile PPPoA Connection Billion 400G Router MPoA Connection IPoA Routed Connection Pure Bridge All PPPoEAdsl Mode System Time ZoneRemote Access Firmware UpgradeBackup / Restore Restart Router User ManagementBillion 400G Router Firewall and Access Control Changed General SettingsThis with caution when connecting over the WAN Packet Filter Example Predefined Port Filters Rules Packet Filter Add TCP/UDP Filter Packet Filter Add Raw IP Filter Billion 400G Router Configuring Packet Filter Example Intrusion Detection Block DurationBillion 400G Router Show Log Intrusion Name Detect Parameter BlacklistType of Block Drop Packet Duration URL Filter Billion 400G Router IM / P2P Blocking Instant Message Blocking The default is set to DisabledPeer to Peer Blocking The default is set to Disabled QoS Quality of Service Firewall LogPrioritization HighWireless Adsl Router Standard Dscp Dscp Mapping TableOutbound IP Throttling LAN to WAN Inbound IP Throttling WAN to LAN Connection Diagram Information and SettingsMission-critical application Restricted Application Billion 400G Router Virtual Server known as Port Forwarding Add Virtual ServerBillion 400G Router Add Click it to apply your settings ExampleGo to ConfigurationVirtual ServerEdit DMZ Host Edit DMZ HostGlobal IP Address Go to ConfigurationVirtual ServerEdit One-to-one NATEdit One-to-One NAT Network Address Translation Protocol Description Port NumberWell-known and registered Ports Time Schedule Delete a Time Slot Configuration of Time ScheduleEdit a Time Slot Static Route Go to Configuration/Advanced/Static RouteAdvanced Dynamic DNS Dynamic DNSCheck Email Check EmailDevice Management From RFC 1213 MIB-II Universal Plug and Play UPnPSnmp V1 From RFC1650 EtherLike-MIB From RFC 1493 Bridge MIBFrom RFC 1471 PPP/LCP MIB From RFC 1472 PPP/Security MIBVlan Bridge DisableLogout Problems with the LAN Interface Problems starting up the routerProblems with the WAN Interface Contact Telkom Adsl support Contact SizweBroadband for Router Support