XP SBC HC 350.1
General information | Controls |
Easy transmission
The FM headphone is able to receive signals from the transmitter, even through barriers such as doors, walls and windows.
Multiple headphones with one transmitter
An additional number of headphones and/or wireless speakers can be used with a single transmitter if they:
-operate in the 433 MHz band
-can detect a 19 kHz pilot tone.
Please consult the appliance’s electrical specification sheets for confirmation on compatibility.
Kit contents
This FM headphone system consists of the following accessories:
1 x SBC HC352 FM transmitter
1 x SBC HC355 FM headphone
1 x SBC CS030/00 12Volt / 200mA AC/DC adapter (for UK: SBC CS030/05 12 Volt/ 200 mA AC/DC adapter)
2 x rechargeable batteries LR03/AAA (NiCd), 220 mAh
1 x 3.5 mm plug to 6.3 mm stereo adapter plug
1 x antenna tube
Transmitter (figure 1)
1Recharging indicator – the green LED lights up during recharging. Completely flat batteries will be fully charged after about 16 hours.
2Power indicator – lights up when audio signals are detected at the audio input.
3Recharging compartment – just place the batteries in the transmitter’s battery compartment.The green LED lights up during recharging.
4DC power – connect to the 12 Volt/ 200 mA AC/DC adapter
53.5 mm stereo headphone audio input – connects your FM transmitter to an audio source
6Channel switch – select one of
2 channels for best reception. We advise you to select channel 1 as a first option.
7Controls plate Headphone (figure 2)
8Power indication – lights up when in use.
9Power On/Off – slide the switch to the on or off position to switch the headphone on/off.
10Battery compartment – remove the earcushion, take out the batteries and put them in the transmitter’s recharging compartment for recharging.
11Volume – adjust volume to your desired listening level.
12Tuning – turn the tuning wheel until the signal is at its clearest.
English
5