Philips HC350 manual Audio Connections, Headphone battery replacement figure, Basic operation

Page 7

XP SBC HC 350.1 21-06-2001 09:51 Pagina 7

Installation

Audio Connections

Headphone battery replacement (figure 3)

IMPORTANT

Use only rechargeable LR03/AAA NiCd batteries (preferably Philips).

Do not use NiMH batteries or alkaline batteries as these may damage your FM wireless system!

1Remove the earcushions.

2Take out the batteries and dispose of them properly.

3Insert new batteries. Only use LR03/AAA NiCd batteries (preferably Philips).

4Make sure the batteries are correctly inserted as indicated by the engraved symbols in the battery compartment.

5Put the earcushions back on the earshell.

IMPORTANT

Before using the FM headphone for the first time, please ensure that the batteries are fully charged for about 16 hours.This will guarantee a longer operating lifetime of the batteries.

Connecting the FM transmitter to a headphone output of an audio source (figure 4)

1Connect the 3.5mm stereo plug of the stereo audio cable to the headphone output of an audio source, such as TV, HiFi or PC.

In case your audio source has a 6.3mm headphone output, use the supplied 3.5mm to 6.3 mm stereo adapter plug.

2Switch on your audio source and carefully increase the volume of the audio source. The red power indication LED of the transmitter lights up if receiving an audio signal.

3Switch on the headphone.You may hear a hissing sound through the headphone if the headphone is not yet properly tuned to the transmitter.

4To tune, turn the tuning wheel until the signal is at its clearest.

5Adjust the volume to the desired level with the headphone volume control.

Basic operation

When the FM transmitter is connected to a headphone output of an audio source.

1Switch on your audio source and carefully increase the volume of the audio source. The red power indication LED of the transmitter lights up if receiving an audio signal.

2Switch on the headphone.You may hear a hissing sound through the headphone if the headphone is not yet properly tuned to the transmitter.

3To tune, turn the tuning wheel until the signal is at its clearest.

4Adjust the volume to the desired level with the headphone volume control.

English

7

Image 7
Contents HC350 350.1 21-06-2001 0951 English Italiano Español18 IndexCongratulations Introduction General informationGeneral information Controls Kit contentsTransmitter power supply InstallationHeadphone power supply Basic operation Headphone battery replacement figureAudio Connections Put the earcushions back on the earshellDistorted sound TroubleshootingProblem Remedy No soundDistorted sound Maintenance Regulations SpecificationsCongratulazioni Introduzione Informazioni generaliContenuto del kit Informazioni generali ComandiAlimentazione della trasmittente InstallazioneAlimentazione della cuffia Funzionamento di base Installazione Collegamenti audioSuono distorto Problema RimedioRicerca dei guasti Assenza di suonoManutenzione Sicurezza dascoltoRegolazioni CaratteristicheDistorsione % THD Separazione dei canali 30 dB ¡Enhorabuena Introducción Información generalContenido del kit MandosFuente de alimentación del transmisor InstalaciónFuente de alimentación de los auriculares Cambio de las pilas de los auriculares figura Conexiones de audioFuncionamiento básico Sonido distorsionado Resolución de problemasProblema Solución No hay sonido¡Cuidado de sus oídos Resolución de problemasMantenimiento Distorsión % THD Separación de canales 30 dB Especificaciones ReglamentoSFM RF/FM Philips433 MHz Volt/200 mA AC/DCAC/DC HiFi LR03 AAA NiCd Philips NiMH LR03/AAA NiCdDC p HC8392. O HC8395 HC8395 LR03/AAA NiMH Philips ETS 300 433.5 MHzMeet Philips at the Internet