Cisco Systems 1900 Series manual Setting Up the Chassis, Chassis Airflow Diagram

Chapter 4 Installing and Connecting the Router

Setting Up the Chassis

Warning Ultimate disposal of this product should be handled according to all national laws and regulations.

Statement 1040

Safety Warnings for Finland, Norway and Sweden

Warning statement 1017 applies to the countries of Finland, Norway, and Sweden.

Warning This unit is intended for installation in restricted access areas. A restricted access area can be accessed only through the use of a special tool, lock and key, or other means of security.

Statement 1017

Setting Up the Chassis

The Cisco 1900 series router can be installed on a desktop, and can also be mounted on a wall. Select the setup that best meets the needs of your network. These setups are described in the following sections:

•Chassis Airflow Diagram, page 4-3

•Setting the Chassis on a Desktop, page 4-4

•Chassis Grounding, page 4-4

•Wall-Mounting the Chassis, page 4-4

•Rack-Mounting the Chassis, page 4-7

Caution The front panel bezel must not be removed from the Cisco 1900 series router. It is part of the product's enclosure, and must be left in place to prevent damage from foreign parts entering the router, to provide a shield from internal electromagnetic interference (EMI), and to direct the flow of cooling air properly through the chassis.

Chassis Airflow Diagram

Figure 4-1shows the airflow through and around the Cisco 1905 and Cisco 1921 chassis.

Figure 4-1 Cisco 1905 and Cisco 1921 Chassis Airflow

Cisco
1900	Series

SYS ACT POE

253716

Cisco 1900 Series Hardware Installation

OL-19084-02 4-3