Cisco Systems 1900 Series Powering up the Router, Checklist Before Powering Up the Cisco Router

C H A P T E R 5

Configuring the Router

This chapter describes how to power up the router and perform the initial configuration in the following sections:

•Powering up the Router, page 5-1

•Performing the Initial Configuration on the Router, page 5-3

–Using the Cisco Setup Command Facility, page 5-3

–Using Cisco Configuration Professional Express, page 5-6

–Using the Cisco CLI—Manual Configuration, page 5-6

•Verifying the Initial Configuration, page 5-23

Powering up the Router

Warning Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement 1029

•Checklist Before Powering Up the Cisco Router, page 5-1

•Powering Up the Cisco Router, page 5-2

•Verifying the Front Panel LED Indications, page 5-3

Checklist Before Powering Up the Cisco Router

Check the following items before powering up the router:

•You have securely mounted and grounded the chassis.

•You have connected the power and interface cables.

•You have properly seated the external Compact Flash memory card into its slot. For installation instructions, see Installing and Upgrading Internal Modules and FRUs in Cisco 1900 Series ISRs.

Cisco 1900 Series Hardware Installation

OL-19084-02 5-1