Cabletron Systems 9C114 manual Installing SmartSwitch 9000 Interface Modules

Installing the 9Cx14 Chassis

				EPIM
				STATUS
				ALARM
			9C300-1			COM 1 COM 2						ENTER
ENVIRONMENTAL MODULE
1	2	3	4	5	6	7	8	9	10	11	12	13	14
													ALWAYS USE ESD	ESD WRIST STRAP
													WRIST STRAP WHEN	GROUNDING
													HANDLING MODULES	RECEPTACLE

Figure 1-5. Installing the Environmental Module

Installing SmartSwitch 9000 Interface Modules

SmartSwitch 9000 Interface Modules can be installed in any of the 14 slots that are available. To install Interface Modules, follow the steps below:

1.Remove the blank panel, covering the slot in which the Interface Module will be installed. All other slots must remain covered to ensure proper airflow and cooling.

2.Unpack the Interface Module by carefully removing it from the shipping box. (Save the box and packing materials in the event the module must be reshipped.)

3.Remove the Interface Module from the plastic bag. (Save the bag in the event the Interface Module must be reshipped.) Observe all precautions to prevent damage from Electrostatic Discharge (ESD).

4.Examine the Interface Module, carefully checking for damage. If any damage exists, DO NOT install the Interface Module. Immediately contact Cabletron Systems Technical Support.

1-12