Cabletron Systems 9C114 manual Installing SmartSwitch 9000 Interface Modules

Page 21

Installing the 9Cx14 Chassis

5.Install the Interface Module in the chassis by sliding it in any available slot and locking down the top and bottom plastic tabs, as shown in Figure 1-6. Take care that the Interface Module slides in straight and properly engages the backplane connectors. When installing the Interface Module, ensure that the circuit card is between the card guides, as shown in Figure 1-6. Check both the upper and lower tracks.

6.If you are installing additional Interface Modules, repeat steps 1–5.

Plastic Locking Tab

Plastic Locking Tab

Metal Back-Panel	Circuit Card
	Card Guides	2031_02

Figure 1-6. Installing SmartSwitch 9000 Interface Modules

1-13

Image 21

Contents SmartSwitch 9C114 and 9C714 Chassis Installation Guide Page Page FCC Notice Vcci NoticeIndustry Canada Notice European Representative Address Declaration of Conformity AddendumPage Contents Contents Features SmartSwitchFlexible Network Bus Descriptions of the seven backplane buses are as follows Your email address Getting HelpUnpacking the SmartSwitch 9000 Chassis InstallationSite Guidelines Required ToolsInstallation Order Rack Mounting the Chassis Rack Mounting the ChassisInstalling a Power Supply Installing a Power Supply Attaching the ESD Wrist Strap Attaching the Electrostatic Discharge ESD Wrist StrapInstalling the Environmental Module Installing the Environmental Module Installing SmartSwitch 9000 Interface ModulesInstalling SmartSwitch 9000 Interface Modules Attaching 9C614 INB Terminator Modules Attaching the INB Terminator Modules Powering up the SmartSwitchEnvironmental Requirements Operating SpeciﬁcationsRegulatory Compliance 9C114 MMAC-Plus Chassis9C214-1 Power Supply 9C714 MMAC-Plus Chassis9C300-1 Environmental Module 9C614 INB Terminator Module

Related manuals

Manual 36 pages 7.13 Kb

Manual 14 pages 9.57 Kb