Cabletron Systems 36, FOMIM-32, 38 manual Related Manuals, Getting Help

Page 13

Chapter 1: Introduction

Error (ERR) LED

When lit, this red LED indicates the temperature within the MMAC chassis has risen to 40°C or greater. The FOMIM alerts the management board, and the FOMIM in turn receives a signal to light the LED.

1.5RELATED MANUALS

The manuals listed below should be used to supplement the procedures and other technical data provided in this manual. The procedures contained in these manuals will be referenced, rather than repeated, in this manual.

Cabletron Systems Multi Media Access Center (MMAC-M3FNB, MMAC-M5FNB, and MMAC-M8FNB) Overview and Set Up Guides.

Cabletron Systems FOT-F3 Fiber Optic Transceiver User's Manual.

1.6GETTING HELP

If you need additional support related to this device, or if you have any questions, comments, or suggestions concerning this manual, contact Cabletron Systems Technical Support:

By phone

(603) 332-9400

 

Monday – Friday; 8 A.M. – 8 P.M. Eastern Time

By CompuServe

GO CTRON from any ! prompt

By Internet mail

support@ctron.com

By FTP

ctron.com (134.141.197.25)

Login

anonymous

Password

your email address

Before calling Cabletron Systems Technical Support, have the following information ready:

A description of the failure

A description of any action(s) already taken to resolve the problem (e.g., changing mode switches, rebooting the unit, etc.)

A description of your network environment (layout, cable type, etc.)

Network load and frame size at the time of trouble (if known)

1-6

FOMIM User’s Guide

Image 13
Contents USER’S Guide Fomim User’s Guide FCC NoticeVcci Notice DOC NoticeCabletron SYSTEMS, INC. Program License Agreement Cabletron Software Program License Exclusion of Warranty and Disclaimer of LiabilityUnited States Government Restricted Rights PO Box Rochester, NH Declaration of ConformityContents Contents Fomim User’s Guide Chapter Introduction Using this ManualIntroduction Fiber Optic Media Interface Modules Document ConventionsDistance and Cable Type Lanview Status Monitoring System Multi Media Access CentersLanview Status Monitoring System Getting Help Related ManualsGetting Help Fomim User’s Guide Network Cable Requirements Chapter Network Requirements InstallationFiber Optic Network Design Guidelines Unpack the module as follows Unpacking the FomimInstalling the Fomim Installing the Fomim Into the MmacST Connector Insertion Connecting Fiber Optic Cabling to the FomimConnecting Fiber Optic Cabling to the Fomim Fomim User’s Guide Installation Test Chapter Testing and TroubleshootingTesting the Fiber Optic Link Segment Link Test PRE-INSTALLATION Test Pre-Installation Test Using LanviewUsing Lanview Fomim User’s Guide Operating Specifications Appendix a Fomim SpecificationsAppendix a Fomim Specifications Environmental RequirementsPhysical Properties Agency ApprovalsFomim User’s Guide ERR LED IndexIndex Index-2 Fomim User’s Guide