Cabletron Systems 38, FOMIM-32, 36 manual Unpacking the Fomim, Unpack the module as follows

Page 17

Chapter 2: Network Requirements and Installation

Propagation delay is the amount of time it takes a packet to travel from the sending device to the receiving device. Total propagation delay allowed for the entire network is 25.6 ∝s. If the total propagation delay between any two nodes on the network exceeds 25.6 ∝s, then bridges should be used.

•When using single mode fiber optic cable, segment lengths up to 5 km are possible if system budgets are met.

2.2UNPACKING THE FOMIM

Unpack the module as follows:

The module is very sensitive to static discharge. Observe all

!electrostatic precautions while handling the FOMIM.

C AUT IO N

1.Remove the shipping material covering the FOMIM in the shipping box.

2.Verify the contents of the shipping box. The box, as packed should contain one FOMIM, one grounding strap, and one user’s guide.

3.Carefully remove the FOMIM from the shipping box. Leave the module in its conductive bag until you are ready to install it. Save the shipping box and materials in the event the unit has to be reshipped.

4.Visually inspect the module within the nonconductive bag. If you see any damage, contact Cabletron Systems Technical Support immediately.

2-2

FOMIM User’s Guide

Page 16 Page 18
Image 17
Page 16 Page 18
Contents USER’S Guide Fomim User’s Guide FCC NoticeCabletron SYSTEMS, INC. Program License Agreement DOC NoticeVcci Notice United States Government Restricted Rights Exclusion of Warranty and Disclaimer of LiabilityCabletron Software Program License PO Box Rochester, NH Declaration of ConformityContents Contents Fomim User’s Guide Chapter Introduction Using this ManualIntroduction Distance and Cable Type Document ConventionsFiber Optic Media Interface Modules Lanview Status Monitoring System Multi Media Access CentersLanview Status Monitoring System Getting Help Related ManualsGetting Help Fomim User’s Guide Fiber Optic Network Design Guidelines Chapter Network Requirements InstallationNetwork Cable Requirements Unpack the module as follows Unpacking the FomimInstalling the Fomim Installing the Fomim Into the MmacST Connector Insertion Connecting Fiber Optic Cabling to the FomimConnecting Fiber Optic Cabling to the Fomim Fomim User’s Guide Testing the Fiber Optic Link Segment Chapter Testing and TroubleshootingInstallation Test Link Test PRE-INSTALLATION Test Pre-Installation Test Using LanviewUsing Lanview Fomim User’s Guide Operating Specifications Appendix a Fomim SpecificationsAppendix a Fomim Specifications Environmental RequirementsPhysical Properties Agency ApprovalsFomim User’s Guide ERR LED IndexIndex Index-2 Fomim User’s Guide
Top Page Image Contents