Cabletron Systems E3100, E1100 manual E1112 Adapter, Preparing the E2100 for Installation

Page 14

INSTALLATION

Boot PROM

Socket

JP1

JP2

I/O Base

ROM

Address

Enable

Figure 2-1. The E1112 Adapter

2.2.4 Preparing the E2100 for Installation

The E21xx Series employs a socket for an optional Boot PROM. All parameters except the I/O base address and PROM base address are set through software. Instructions are included for setting the I/O base address, and installing the Boot PROM. Figure 2-2, an E2112 adapter, shows the locations of the jumpers and Boot PROM socket. Boot PROM addressing is covered in the installation instructions included with the Boot PROM.

 

 

 

 

 

 

Boot PROM Socket

 

JP1

JP2

 

 

I/O Base Address

ROM Enable

Figure 2-2. The E2112 Adapter

Page 2-4

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Desktop Network Interface Products Page FCC Notice Contents Making Network Connections Appendix a ADDRESS/INTERRUPT Tables IndexUsing this Manual Chapter IntroductionThin Ethernet Port Adapter FeaturesConnectivity 3 10BASE-T Twisted Pair PortLanview LEDs Fiber Optic PortsJabber Protection Collision Present CLN Related Manuals SoftwareStatistics Chapter Installation Adapter ModelsModel Number References E1100/E2100 Series AdaptersCopying the Software Preparing the E1100 for InstallationUnpacking the Adapter Preparing the E2100 for Installation E1112 AdapterSetting the I/O Base Address Jumper JP1, E1100/E2100 I/O base address Jumper Pins 220 280 300Installing a Boot Prom I/O Address Space RequirementsInstalling the E1100/E2100 Adapters Backplate Detail Installing the E1100 Series Adapter 2 E3100 Series Boot Prom Installing the E3100 Series AdaptersPreparing the E3100 Series for Installation Installing the E3100 Adapter E3112 AdapterBackplate Thumbscrew Clip Adapter Edge Connector Expansion Slot Copying the ADF File Loading Network SoftwareTroubleshooting Check List for Adapters Software Check ListGetting Help Support@ctron.com Safety SpecificationsPower Requirements DimensionsChapter Making Network Connections Attaching a UTP SegmentTX+ Twisted Pair Requirements Connecting to a THIN-NET Segment BNC Interface Coax PortAttaching a Thin-Net Segment Thin-Net RequirementsConnecting to a Fiber Optic Link Segment ST Fiber Optic Connectors Fiber Optic RequirementsFiber Optic Interface Fiber Optic Ports Wire Fault/Attachment LED AUI Port AUI Connector Screws AUI Interface AUI Cable RequirementsAppendix a ADDRESS/INTERRUPT Tables Table A-1. I/O Ports of Common DevicesA-2 Index Index
Top Page Image Contents