Cabletron Systems E2100, E1100, E3100 manual FCC Notice

Page 3

FCC NOTICE

FCC NOTICE

This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

WARNING: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required at his own expense to correct the interference.

If this equipment does cause interference to radio or television, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Re-orient the receiving antenna.

Relocate the computer with respect to the antenna.

Move the computer away from the receiver.

Plug the computer into a different outlet so that the computer and the receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user may find the following booklet prepared by the Federal Communication Commission helpful:

“Interference Handbook”

This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402 - Stock No. 004-000-00482-5.

ii

Image 3
Contents Desktop Network Interface Products Page FCC Notice Contents Appendix a ADDRESS/INTERRUPT Tables Index Making Network ConnectionsChapter Introduction Using this Manual3 10BASE-T Twisted Pair Port Adapter FeaturesConnectivity Thin Ethernet PortFiber Optic Ports Jabber ProtectionLanview LEDs Collision Present CLN Software StatisticsRelated Manuals Adapter Models Chapter InstallationE1100/E2100 Series Adapters Model Number ReferencesPreparing the E1100 for Installation Unpacking the AdapterCopying the Software E1112 Adapter Preparing the E2100 for InstallationJP1, E1100/E2100 I/O base address Jumper Pins 220 280 300 Setting the I/O Base Address JumperI/O Address Space Requirements Installing a Boot PromInstalling the E1100/E2100 Adapters Backplate Detail Installing the E1100 Series Adapter Installing the E3100 Series Adapters Preparing the E3100 Series for Installation2 E3100 Series Boot Prom E3112 Adapter Installing the E3100 AdapterBackplate Thumbscrew Clip Adapter Edge Connector Expansion Slot Loading Network Software Copying the ADF FileSoftware Check List Troubleshooting Check List for AdaptersGetting Help Support@ctron.com Dimensions SpecificationsPower Requirements SafetyAttaching a UTP Segment Chapter Making Network ConnectionsTX+ Twisted Pair Requirements BNC Interface Coax Port Connecting to a THIN-NET SegmentThin-Net Requirements Attaching a Thin-Net SegmentConnecting to a Fiber Optic Link Segment Fiber Optic Requirements ST Fiber Optic ConnectorsFiber Optic Interface Fiber Optic Ports Wire Fault/Attachment LED AUI Port AUI Connector Screws AUI Cable Requirements AUI InterfaceTable A-1. I/O Ports of Common Devices Appendix a ADDRESS/INTERRUPT TablesA-2 Index Index