Cabletron Systems E3100, E2100, E1100 manual Clip Adapter Edge Connector Expansion Slot

Page 23

INSTALLATION

•Align the adapter so the PC bus edge connector is lined up with the expansion slot (4) as shown in Figure 2-11.

1

5 2

3

1. Clip

42. Adapter

3. Edge Connector

4. Expansion Slot

5. Clip

Figure 2-11. Installing the E3100 Series Adapter

•Slide the adapter into the guide slots and firmly press, but do not force, the adapter into the expansion slot. The plastic clips on the adapter (1, 5, Figure 2-11) will snap into place as the adapter is inserted into the expansion slot.

•Reinsert the thumbscrew, and replace the PC cover. Reattach the power and peripheral cables, and power up the PC.

Page 2-13

Image 23

Contents Desktop Network Interface Products Page FCC Notice Contents Appendix a ADDRESS/INTERRUPT Tables Index Making Network ConnectionsChapter Introduction Using this Manual3 10BASE-T Twisted Pair Port Adapter FeaturesConnectivity Thin Ethernet PortLanview LEDs Fiber Optic PortsJabber Protection Collision Present CLN Related Manuals SoftwareStatistics Adapter Models Chapter InstallationE1100/E2100 Series Adapters Model Number ReferencesCopying the Software Preparing the E1100 for InstallationUnpacking the Adapter E1112 Adapter Preparing the E2100 for InstallationJP1, E1100/E2100 I/O base address Jumper Pins 220 280 300 Setting the I/O Base Address JumperI/O Address Space Requirements Installing a Boot PromInstalling the E1100/E2100 Adapters Backplate Detail Installing the E1100 Series Adapter 2 E3100 Series Boot Prom Installing the E3100 Series AdaptersPreparing the E3100 Series for Installation E3112 Adapter Installing the E3100 AdapterBackplate Thumbscrew Clip Adapter Edge Connector Expansion Slot Loading Network Software Copying the ADF FileSoftware Check List Troubleshooting Check List for AdaptersGetting Help Support@ctron.com Dimensions SpecificationsPower Requirements SafetyAttaching a UTP Segment Chapter Making Network ConnectionsTX+ Twisted Pair Requirements BNC Interface Coax Port Connecting to a THIN-NET SegmentThin-Net Requirements Attaching a Thin-Net SegmentConnecting to a Fiber Optic Link Segment Fiber Optic Requirements ST Fiber Optic ConnectorsFiber Optic Interface Fiber Optic Ports Wire Fault/Attachment LED AUI Port AUI Connector Screws AUI Cable Requirements AUI InterfaceTable A-1. I/O Ports of Common Devices Appendix a ADDRESS/INTERRUPT TablesA-2 Index Index