Cabletron Systems E2100, E1100, E3100 manual Backplate Detail

Page 18

INSTALLATION

Carefully remove the adapter from its protective pouch, and visually inspect it.

Remove the backplate (2, Fig. 2-6) from the selected slot (3) by removing the screw (1) holding the backplate in place, and sliding the backplate out of the slot as shown in Figure 2-6.

Carefully insert the adapter into the expansion slot as shown in Figures 2-7 and 2-8. Orient the adapter (1) so the PC edge bus connector (2) is pointed down and the ports face out the back of the PC. Align the adapter so the PC bus edge connector is lined up with the expansion slot (3), and firmly press, but do not force, the adapter into the slot.

 

 

1

 

3

2

1.

Screw

 

 

 

 

2.

Backplate

 

 

3.

Expansion Slot

Figure 2-6. Backplate Detail

Page 2-8

Image 18
Contents Desktop Network Interface Products Page FCC Notice Contents Making Network Connections Appendix a ADDRESS/INTERRUPT Tables IndexUsing this Manual Chapter IntroductionThin Ethernet Port Adapter FeaturesConnectivity 3 10BASE-T Twisted Pair PortFiber Optic Ports Jabber ProtectionLanview LEDs Collision Present CLN Software StatisticsRelated Manuals Chapter Installation Adapter ModelsModel Number References E1100/E2100 Series AdaptersPreparing the E1100 for Installation Unpacking the AdapterCopying the Software Preparing the E2100 for Installation E1112 AdapterSetting the I/O Base Address Jumper JP1, E1100/E2100 I/O base address Jumper Pins 220 280 300Installing a Boot Prom I/O Address Space RequirementsInstalling the E1100/E2100 Adapters Backplate Detail Installing the E1100 Series Adapter Installing the E3100 Series Adapters Preparing the E3100 Series for Installation2 E3100 Series Boot Prom Installing the E3100 Adapter E3112 AdapterBackplate Thumbscrew Clip Adapter Edge Connector Expansion Slot Copying the ADF File Loading Network SoftwareTroubleshooting Check List for Adapters Software Check ListGetting Help Support@ctron.com Safety SpecificationsPower Requirements DimensionsChapter Making Network Connections Attaching a UTP SegmentTX+ Twisted Pair Requirements Connecting to a THIN-NET Segment BNC Interface Coax PortAttaching a Thin-Net Segment Thin-Net RequirementsConnecting to a Fiber Optic Link Segment ST Fiber Optic Connectors Fiber Optic RequirementsFiber Optic Interface Fiber Optic Ports Wire Fault/Attachment LED AUI Port AUI Connector Screws AUI Interface AUI Cable RequirementsAppendix a ADDRESS/INTERRUPT Tables Table A-1. I/O Ports of Common DevicesA-2 Index Index