Cabletron Systems FPIM-02 manual Installing the Module into the SmartSwitch 9000 Chassis

Page 16
Installing the Module into the SmartSwitch 9000 Chassis

Installing the SmartSwitch 9000 Module

Installing the Module into the SmartSwitch 9000 Chassis

To install the SmartSwitch 9000 module, follow the steps below:

NOTE

The INB Terminator Modules must be installed on the rear of the chassis before powering up this module. Refer to the INB Terminator Modules Installation Guide for information and installation procedure.

1.Remove the blank panel covering the two slots in which the module is being installed. All other slots must be covered, if other modules are not being installed, to ensure proper airflow and cooling.

2.Attach one end of the ESD wrist strap packaged with the SmartSwitch 9000 chassis to your wrist. Plug the other end into the ESD Wrist Strap Grounding receptacle in the lower right corner of the SmartSwitch 9000 Chassis shown in Figure 2-2.

3.Grasp the module and slide it into the slots. Make sure that the module’s circuit card is between the card guides, as shown in Figure 2-2. Check both the upper and lower tracks the card. Take care that the module slides in straight and engages the backplane connectors properly.

4.Lock down the top and bottom plastic tabs, as shown in Figure 2-2.

2-4

Image 16
Contents SmartSwitch 9M426-02 User’s Guide 9032531-01Page Copyright February 1998 by Cabletron Systems, Inc 35 Industrial Way VCCI Notice FCC NoticeDOC Notice Nexus House, Newbury Business Park DECLARATION OF CONFORMITY ADDENDUMConformance to Directives/Product Standards Page Contents Contents Introduction FeaturesChapter Introduction ConnectivityManagement Information Base MIB Support LANVIEW LEDs9M426-02 Figure 1-1. The 9M426-02 ModuleSMB CPU INB Related Manuals Getting HelpSmartSwitch 9000 Installation Guide SmartSwitch 9000 9C300-1 Environmental Module User’s GuideUser Accessible Components Installing the SmartSwitch 9000 ModuleUnpacking the Module Installing the SmartSwitch 9000 Module SMB-1 PROM i960 Processor Boot PROMDIP Switch Local DRAMSee the Cautions at the end of this table Installing the Module into the SmartSwitch 9000 Chassis Ensure that the circuit card is between the card guides Jack for ESD wrist strap Metal Back-Panel Circuit Card Card GuidesThe Reset Switch Operation System Management BusesSystem Diagnostic Controller SecureFast SwitchDC/DC Converter INB Interfacei960 Core Operation LANVIEW LEDs System Status FNB Transmit9M426-02 FNB ReceiveLED Color LANVIEW LEDsState Safety SpecificationsTechnical Specifications Service Physical