Cabletron Systems FPIM-02 manual FCC Notice, VCCI Notice, DOC Notice

Page 4
FCC Notice

Notice

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

VCCI Notice

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

DOC Notice

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

ii

Image 4
Contents SmartSwitch 9M426-02 User’s Guide 9032531-01Page Copyright February 1998 by Cabletron Systems, Inc 35 Industrial Way VCCI Notice FCC NoticeDOC Notice Nexus House, Newbury Business Park DECLARATION OF CONFORMITY ADDENDUMConformance to Directives/Product Standards Page Contents Contents Introduction FeaturesChapter Introduction ConnectivityManagement Information Base MIB Support LANVIEW LEDs9M426-02 Figure 1-1. The 9M426-02 ModuleSMB CPU INB Related Manuals Getting HelpSmartSwitch 9000 Installation Guide SmartSwitch 9000 9C300-1 Environmental Module User’s GuideUser Accessible Components Installing the SmartSwitch 9000 ModuleUnpacking the Module Installing the SmartSwitch 9000 Module SMB-1 PROM i960 Processor Boot PROMDIP Switch Local DRAMSee the Cautions at the end of this table Installing the Module into the SmartSwitch 9000 Chassis Ensure that the circuit card is between the card guides Jack for ESD wrist strap Metal Back-Panel Circuit Card Card GuidesThe Reset Switch Operation System Management BusesSystem Diagnostic Controller SecureFast SwitchDC/DC Converter INB Interfacei960 Core Operation LANVIEW LEDs System Status FNB Transmit9M426-02 FNB ReceiveLED Color LANVIEW LEDsState Safety SpecificationsTechnical Specifications Service Physical