Cabletron Systems FPIM-02 System Diagnostic Controller, DC/DC Converter, INB Interface, Operation

Page 20
Operation

Operation

band from user data. Modules which share the SMB-10 bus periodically send out loop-back packets to ensure the validity of SMB-10. In the event a fault is detected on the SMB-10, the SMB-1 can be used as an alternate communication channel by the modules.

System Diagnostic Controller

This diagnostic controller is composed of a Z-80 microprocessor and its supporting logic. The diagnostic controller is designed to control the power-up sequencing of modules, monitor the 9M426-02 input and output power parameters, keep watch over the main host processor, as well as monitor the temperature and control the SMB LANVIEW diagnostic LED. Although the diagnostic controller and the main host processor can operate independent of each other if needed, they exchange information about each other’s status and overall module condition. The information gathered by the diagnostic controller is available to the network manager via local/remote management and the LCD located on the environment module. The 9M426-02 has been designed so that in the event of a diagnostic controller fault, the 9M426-02 will continue to function.

DC/DC Converter

The DC/DC converter converts the 48 VDC on the system power bus to the necessary operating voltages for its host network services module. The diagnostic controller monitors and controls the operation of the DC/DC converter.

INB Interface

Each module that attaches to the INB has an INB Network Interface Block (NIB). The INB NIB converts canonical frames to fixed length data blocks for transmission onto the INB. For data blocks received from the INB, the INB NIB reassembles the data blocks received from the INB back into canonical frames for transmission to the SmartSwitch ASIC then from the SmartSwitch ASIC to the front panel ports.

SecureFast Switch

The SmartSwitch ASIC is a hardware based switch design that is the key building block of the SmartSwitch 9000. All filtering/forwarding decisions are made in hardware as opposed to software as in traditional switches. This custom hardware allows the SmartSwitch ASIC to process over 150K frames per second. The SmartSwitch ASIC is designed to support up to 64 ports that are shared

3-2

Page 19 Page 21
Image 20
Page 19 Page 21
Contents SmartSwitch 9M426-02 User’s Guide 9032531-01Page Copyright February 1998 by Cabletron Systems, Inc 35 Industrial Way DOC Notice FCC NoticeVCCI Notice Conformance to Directives/Product Standards DECLARATION OF CONFORMITY ADDENDUMNexus House, Newbury Business Park Page Contents Contents Chapter FeaturesIntroduction Introduction ConnectivityManagement Information Base MIB Support LANVIEW LEDsSMB CPU INB Figure 1-1. The 9M426-02 Module9M426-02 Related Manuals Getting HelpSmartSwitch 9000 Installation Guide SmartSwitch 9000 9C300-1 Environmental Module User’s GuideUnpacking the Module Installing the SmartSwitch 9000 ModuleUser Accessible Components Installing the SmartSwitch 9000 Module SMB-1 PROM i960 Processor Boot PROMDIP Switch Local DRAMSee the Cautions at the end of this table Installing the Module into the SmartSwitch 9000 Chassis Ensure that the circuit card is between the card guides Jack for ESD wrist strap Metal Back-Panel Circuit Card Card GuidesThe Reset Switch Operation System Management BusesSystem Diagnostic Controller SecureFast SwitchDC/DC Converter INB Interfacei960 Core Operation LANVIEW LEDs System Status FNB Transmit9M426-02 FNB ReceiveState LANVIEW LEDsLED Color Technical Specifications SpecificationsSafety Service Physical
Top Page Image Contents