Cabletron Systems 150 manual Verify the Installation

Page 44

EXAMPLE NETWORKS

VERIFY THE INSTALLATION

Steps on how to verify the installation are detailed in the System Verification chapter of the User’s Guide. This section gives an outline of which steps should be executed for Example 3.

On the CyberSWITCH:

Verify hardware resources are operational

Issue dr command

Look for BRI line messages

Look for LAN initialized messages

Check for IP routing initialized message in log

Verify WAN Lines Available

Connect WAN lines

Issue dr command

Look for “Data Link up 1,1” in reports

On each Remote Host:

Attempt to access a resource on the CyberSWITCH LAN. This may require that you reboot your system and proceed through the logon sequence.

Have the remote hosts ping the CyberSWITCH.

Have the CyberSWITCH ping the remote hosts (if a connection is up).

44 CyberSWITCH

Image 44 Contents
Example Networks Virus Disclaimer Trademarks DOC Notice Contents IP Routing Network with Remote Bridge Devices Index Example Networks Simple Remote Bridging Network Resources LinesBridging and Routing Information IP RoutingConfigure the Cyberswitch Line Type = Brisdn Pointtopoint Pointmultipoint Isdn Save Configuration Files Verify the Installation Remote Bridging Network with Security Isdn BRI Device Information Calling ISDN, FR, etc. InformationPat Smith IP Routing Enabled Disabled Mode of Operation Router Configure the Cyberswitch Configuring the OptionsConfiguring the Security Isdn PPP Verify the Installation IP Routing Network Site System Details Rick Jill Ralph Todd SanFran Configuring the Cyberswitch Options SnmpConfiguring the IP Interface Information WAN Rlan LAN WAN Device Name? Rick Bear Device Authentication Menu Device = Rick Bear Return to the Security Configuration Menu Verify the Installation IP Routing Network with Remote Bridge Devices Business AssumptionsIsdn Resources 123123123123 Carmel CorpOffice ENABLE/DISABLE Bridging Configuring the IP Interface Information WAN Rlan Return to the Main Menu Device Name? Monterey Device Table Menu Device = Monterey 198.12.10.0 Save Configuration Files IP Routing Network with PPP Devices IP Routing Network with PPP Devices BRI 5ESS For Site BridgingLAN2 For Site 918105551234 Configure SITE1 Configuring the System OptionsConfiguring the IP Interface Information Screen interaction will resemble the following Device Name? SITE2 Device Table Menu Device = SITE2 Base Data Rate 64000 bps Initial Maximum 384000 bps Configuring Static Routes LAN Interface CSX150 Finishing the Security Configuration Configure SITE2 Configuring SITE2 OptionsConfiguring Security Example Networks IPX Routing Network Masternet Ethernet-1 64000 bps 128000 bps Obpswd Bridging and Routing Information IPX Routing Configure Devices ADD IPX WAN DeviceIsdn Information Configure System Options RIP/SAPAdd a LAN Interface Add a Remote LAN Interface Finally, you’ll see this screen IPX Static Routes Save Configuration Files Appletalk Routing Network Network Topology MAC SITE1 Appletalk Routing AppleTalk Routing/Port InformationPPP Configure the Cyberswitch Configuring Appletalk Port Information Example Networks Configuring Device Information Disabled Again, return to the Device Table Menu Configuring AN Appletalk Static Route Verify the Installation Index