Cabletron Systems 150 manual Configuring the Cyberswitch Options, Snmp

EXAMPLE NETWORKS

CONFIGURE THE CYBERSWITCH

Note: The software should have already been installed and you should see the system prompt before proceeding with these steps.

Using the detailed instructions for these steps found in the Simple Remote Bridging chapter, complete the following configuration steps.

Start the CFGEDIT program

Select physical resources

Select to add a resource

Select Switch type to be 4ESS

Select to add a line

Enter “Line1” as the line name

Select slot 1, port 1

Add Data Links

Choose Auto TEI Negotiation

Enter SPID Value

Enter Directory Number for Data Link

Enter Maximum Number of Digits to Verify

Repeat “Add Data Links” for second Data Link

The following sections provide instructions for completing the remaining configuration steps.

CONFIGURING THE CYBERSWITCH OPTIONS

To begin the configuration of the system options, press 2 at the Main Menu. The following options menu will then be displayed:

Options Menu:

1)Bridging

2)IP

3)IPX Routing

4)AppleTalk

5)SNMP

6)PPP

7)Call Control Options

8)Default Line Protocol

9)Log Options

10)Compression

Select function from above or <RET> for previous menu:

For this example, we only need IP routing enabled. IP routing is already enabled as fault, so no change is necessary.

For this example, the only other IP information we need to configure is for IP interfaces. No static routes are needed because Router 1 supports RIP, which eliminates the need to manually configure a static route. The next section will provide the instructions needed to configure the necessary IP interfaces.

36 CyberSWITCH