Cabletron Systems 150 manual ENABLE/DISABLE Bridging

IP ROUTING NETWORK WITH REMOTE BRIDGE DEVICES

Configure the CyberSWITCH

CONFIGURE THE CYBERSWITCH

Using the detailed instructions found in the Simple Remote Bridging chapter, complete the configuration steps listed below.

Note: The software should have already been installed and the system prompt should be displayed before beginning the configuration.

Start the CFGEDIT program

Select physical resources

Select to add a resource

Select Switch type to be NI-1

Select to add a line

Select slot 1, port 1

Enter “Line1” as the line name

Add Data Links

Choose Auto TEI Negotiation

Enter SPID Value

Enter Directory Number for Data Link

Enter Maximum Number of Digits to Verify

Repeat “Add Data Links” for second Data Link

The following sections provide instructions for completing the remaining configuration steps.

CONFIGURING THE CYBERSWITCH OPTIONS

To begin the configuration of the system options, press 2 at the Main Menu. The options menu will then be displayed.

ENABLE/DISABLE BRIDGING

Whether or not to use bridging depends on network requirements. The RLAN interface will work either way. For this example, we will assume that we only want to route IP traffic onto the corporate LAN. Therefore, we will disable bridging on the CyberSWITCH. IP routing is already enabled as fault, so no change is necessary.

For this example, the only other IP information we need to configure is two IP interfaces. (No static routes are needed.) The next section will provide the instructions needed to configure the necessary IP interfaces.

Small Office Remote Access Switch 51