Extron electronic 3200 Series, 6400 Series manual Ascii H OST-S Witcher Response S WITCHER-H OST

Chapter 4 • Programmer’s Guide

ADVANCED INSTRUCTION SET AND SIMPLE INSTRUCTION SET COMMANDS (PAGE 2 OF 3)

	VIEW COMMANDS	ASCII (HOST-SWITCHER)	RESPONSE (SWITCHER-HOST)
Virtual Output MUTES		VM	1• 2• • • • • 64Mut

Notes:

1.Start output is always Ø1 for Room PRESET, because room has max. of 16 outputs assigned.

2.All “VI” values in responses are 2 numeric characters (i.e. 12 orØ3) or “na” indicating nonexistent virtual outputs.

3.In “VA” View, any outputs that do not follow show as “- -“ in response.

4.Rvo = Virtual Output assigned to specified “room” (up to 16 total).

RGB DELAY COMMANDS	ASCII (HOST-SWITCHER)	RESPONSE (SWITCHER-HOST)
Read RGB Delay (for 1 ch.)	D	Out	•Dly
Set RGB Delay (for 1 ch.)	d *	Out	•Dly

Note: Where = delay in 1/2 second increments (i.e. Ø = Ø sec, 1Ø = 5.Ø sec)

DIRECT WRITE OF

GLOBAL PRESETS COMMAND		ASCII (HOST-SWITCHER)	RESPONSE (SWITCHER-HOST)
Start Write Mode		P	Write Preset	Ready
End Write Mode		p	End Write Preset
Example		P32	Write Preset 32 Ready
	1*1!

1*2&

1*3%

:

:

1*64$

p End Write Preset 32

Notes:

1.Any non-output switching or invalid command between the Start and End commands will be ignored.

2.If there is no activity for 5 seconds while in write mode, then error E17 occurs.

3.No front panel switching (Actual Switching) is allowed during the Start and End commands.

4.If an End ( p) command is issued with no Start command, then error E1Ø occurs.

QUICK RECALL OF

GLOBAL PRESET COMMANDS	ASCII (HOST-SWITCHER)	RESPONSE (SWITCHER-HOST)
Quick Recall Preset	.	RPR

Notes:

1.If the Quick Recall Preset ( .) command is issued without an active write, then error E1Ø occurs.

2.Complete backplane switch within 6ØmS (apprx.) after receipt of the command.

3.Recall must take place 1ØØ mS after End Write Mode command ( p).

4.Quick recall command only recalls last entered direct write preset.

SET NAMES COMMANDS	ASCII (HOST-SWITCHER)		RESPONSE (SWITCHER-HOST)
Read Global preset name	NG
Write Global preset name	nG	,	NamP
Read Room preset name	NP	*
Write Room preset name	nP	* ,	NamP
Read Room Name	NR
Write Room Name	nR	,	NamR
Read Virtual Input Name	NI
Write Virtual Input Name	nI	,	NamI
Read Virtual Output Name	NO
Write Virtual Output Name	nO	,	NamO
ZAP CONFIGURATION COMMANDS	ASCII (HOST-SWITCHER)		RESPONSE (SWITCHER-HOST)
Zap All Global presets & names	zG		ZapG

4-7 Extron • Matrix 3200/6400 Series • User’s Manual