Extron electronic 6400 Series Feature Descriptions, A Matrix 6400 Video Switcher Rear Panel View

Chapter 1 • Introduction to the Matrix 3200/6400 Video Switcher

Feature Descriptions

Virtual Control – Logical assignment of physical Input/Output connector.

Microprocessor Control – A Microprocessor enables the Matrix 3200/6400 Video switcher to be programmed from a host system, or from the optional Front Panel Controller (FPC 1000).

Global Preset configurations (32 +1 ) – Thirty-two Global Preset configurations plus the current I/O configuration are stored in nonvolatile memory. As new configurations are developed, they may be stored as Global Presets (up to a total of thirty-two) in the Preset memory. Any preset may later be recalled – instantly setting the switcher to the desired configuration.

Room configurations – 10 Room configurations with 10 Presets for each Room enables 10 different remote locations to control switching for that particular location using an optional MKP 1000 or MCP 1000 Remote Keypad. Room Configurations may be significantly different from room to room and would probably only include a select number of inputs and outputs per room.

Memory – Nonvolatile memory contents remain valid after power is removed normally or due to a power failure.

RS-232/RS-422 – The Matrix 3200/6400 Video Switcher can be controlled by any remote Host system with serial communications capability.

Rack Mountable metal enclosures – Matrix Video Switchers are housed in 5U high, rack mountable-metal enclosures. An internal switch mode power supply is standard for all models.

Modular Design – The modular design of the Matrix 3200/6400 Video Switcher provides flexibility and expandibility by allowing users to purchase only the modules required for their systems. BMEs may also be upgraded by adding output video cards (8 outputs/card).

Redundant Power Supply (Optional) – If the main power supply fails, the Redundant Power Supply will take over automatically.

FPC 1000 Front Panel Controller (Optional) – The FPC 1000 mounts in place of the blank access panel in the master module (BME #0) and enables the user to perform most configuration operations at the switcher. See FPC 1000 User’s Manual (Extron Part #68-355-02).

			BME				INPUTS							OUTPUTS
			-
			4
			+
A		ADDRESS									OUT	OUT	OUT	OUT	OUT	OUT	OUT	OUT
B			IN	1	9	17	25	33	41	49	57
C
D	COMM.
E
A			SYNC	2	10	18	26	34	42	50	58
	MKP
B
C
D
E			OUT	3	11	19	27	35	43	51	59
	RS232/RS422	ANAHEIM, CA		4	12	20	28	36	44	52	60
		MADE IN USA
IN	BME COMM.			5	13	21	29	37	45	53	61
OUT				6	14	22	30	38	46	54	62
AC POWER INPUT
FUSE: 250V 5.0A TT			SERVICING
				7	15	23	31	39	47	55	63
		5.0A MAX 50/60Hz	POWER CORD BEFORE	8	16	24	32	40	48	56	64
		100-240V	DISCONNECT
											1 - 8	9 - 16	17 - 24	25 - 32	33 - 40	41 - 48	49 - 56	57 - 64

Figure 1-2.A Matrix 6400 Video Switcher (Rear Panel View)

Extron • Matrix 3200/6400 Series • User’s Manual 1-2