e
f
LINK LED — A green LED lights to indicate that the unit is connected to an active network.
ACT LED — A yellow LED lights to indicate that data is being sent or received.
IPL T S6
| COM | CTS |
| COM |
| ||
TX | RX | RTS | TX | RX | TX | RX |
R 1 3 5
2 4 6
1 | 2 | 3 | 3 |
100 4
LINK 5
ACT | 6 |
|
IPL T SFI244
IPL T SFI244
|
| COM | I/O |
| IR | 100 | 7 | |
|
| TX | RX 1 | 3 | 1 | 3 | 8 | |
| R | 1 |
|
|
|
| LINK | |
|
| 2 |
|
|
|
| ACT | 9 |
|
|
| 2 | 4 | 2 | 4 |
| |
1 | 2 | 3 | 4 | 5 |
| 6 |
|
|
a b c
d
Power LED — A green LED lights to indicate that the unit is receiving power.
Reset button — Recessed multiple function Reset button. See Resetting the Controller for more information.
IR learning receiver — This infrared receiver "learns"commands from device IR remote controls. Refer to the IR Learner Software Help file for IR learning procedures.
COM LEDs
e f g
h i
zzTX — A green LED lights to indicate that data is being transmitted.
zzRX — A green LED lights to indicate that data is being received.
I/O LEDs — A green LED lights to indicate that an I/O port (1 through 4) is active.
IR LEDs — A green LED lights to indicate that an IR port (1 through 4) is transmitting data.
100 LED — A green LED lights to indicate that the connection speed is 100 Mbps. If the LED is not lit, the connection speed is 10 Mbps.
LINK LED — A green LED lights to indicate that the unit is connected to an active network.
ACT LED — A yellow LED lights to indicate that data is being sent or received.
10 IPL T Series • Setup