Connections and Wiring

Power Connection

To connect the power supply:

1.Insert the 2-pole captive screw connector into the power supply receptacle on the rear panel of the controller.

SmoothRidges

SECTION A–A

3/16”

(5 mm) Max.

Power Supply Output Cord

MAC: 00-05-A6-XX-XX-XX

S/N:

POWER LAN

12V

.5A MAX

FLEX I/O			IR
COM1 COM2 1 2 3 4	1	2	3	4

TX RX

S G S G S G S G

Power Supply Receptacle

DC Power Cord

Captive Screw Connector

Ground +12 VDC

External

Power Supply

(12 VDC, 1 A )

AC Power Cord

Figure 6. Power Connector Wiring

2.Connect the female end of the AC power cord into the power supply and the male end into a 110-220 VAC outlet.

Local Area Network (LAN) Connection

Connect a patch (straight-through) Ethernet cable to the LAN port on the rear panel if you are connecting the controller to a switch, hub, or router on your A/V network.

Connect a crossover Ethernet cable to the LAN receptacle on the rear panel if you are connecting the controller directly to a PC.

MAC: 00-05-A6-XX-XX-XX S/N:

POWER LAN

12V

.5A MAX

FLEX I/O			IR
COM1 COM2 1 2 3 4	1	2	3	4

TX RX

S G S G S G S G

Local Area Network (LAN) Receptacle

14 IPL T Series • Setup