Extron electronic IPI 200, IPI 100 manual X3$ , X1$ CI, X1* , X1$ CS, EX1$ , X2@ CV

Command	ASCII (Telnet\⤀	URL Encoded	Response	Additional Description
	(host to intercom\⤀	(host to intercom\⤀	(intercom to host\⤀
Read daylight	E CX}	W CX	X3$ ]	X3$See note at bottom of page B-10
saving time

Set DHCP on24	E	}	W1DH	]
	1 DH			Idh 1
Set DHCP off24	E	}	W0DH	]
	0 DH			Idh 0
View DHCP	E DH}		WDH	X% ]
mode
Set IP	E X1$ CI}		W X1$ CI	Ipi• X1$ ]
address24

Setting DHCP to off also resets the unit’s IP address to the factory default (192.168.254.254).

X%= 0 (off) or 1 (on).

X1$= IP address (xxx.xxx.xxx.xxx). Leading zeros in each of the four fields are optional in setting values.

Read IP	E CI}	W CI	X1$ ]
address
Read	E CH}	WCH	X1* ]	or
hardware			Iph•X1* ]

address (MAC)

Leading zeros in each of the four fields are suppressed.

X1*= hardware (MAC) address (xx- xx-xx-xx-xx-xx).

Set subnet	E X1$ CS}	W X1$ CS	Ips• X1$ ]	X1$= IP address or subnet mask
mask24				(xxx.xxx.xxx.xxx).
Read subnet	E CS}	WCS	X1$]	Leading zeros suppressed.
mask
Set gateway IP	EX1$  }	X1$	X1$]	X1$	= IP address or subnet mask
address24	CG	W  CG	Ipg•
				(xxx.xxx.xxx.xxx). Leading zeros are

optional.

Read gateway	E CG}	WCG	X1$ ]
IP address
Set verbose	E X2@ CV}	W X2@ CV	Vrb X2@ ]
response
mode on/off24

X2@= verbose mode status:

0 = clear/none, default for Telnet

connections; responses are not echoed to the host

1 = verbose mode is on, default for RS-232 host control; responses are echoed to the host and displayed to the user

2 = send tagged responses for queries

3 = verbose mode is on and tagged responses are sent for queries.

NIf tagged responses are enabled, all read commands return the constant string + data, the same as for setting a value. For example, for E CN }, the response is Ipn• X1@ ]rather than just the data.

NVerbose mode is a communication mode in which the device responds with more information than it usually would—more than the device, itself, requires. For example, the controller can send out unsolicited information (such as notice of a volume or input change or a change in some other setting). That is an example of a verbose (wordy) relationship between the controller and a connected device. Verbose mode creates more network traffic than usual, which can slow down network performance.

Verbose mode is usually enabled for troubleshooting and disabled for daily use.

•For a direct RS-232 connection, the controller is set for verbose mode by default.

•When the IPI is connected via Ethernet, verbose mode is disabled (by default) in order to reduce the amount of communication traffic on the network. If you want to use the verbose mode with a controller connected via Ethernet, this mode must be set to “on” each time you reconnect to the controller.

IPI 100 and IPI 200 Series • SIS Programming and Control B-11