Extron electronic MTP SW6 user manual Three

Page 18

Installation and Operation, cont’d

4. Adjust the leftmost video signal as follows:

MTP SW6

N The switcher cannot shift the rightmost video image to the left.

a. Use a Tweeker or other small screwdriver to press and release the Delay Select button until the LED lights for the left-shifted color — Delay Red, Green, or Blue.

b. Slowly rotate the Delay Adjust control clockwise while monitoring the display. Observe that the leftmost color shifts rightward one step at a time. Continue to rotate the control until that color is properly converged.

NA 2-nanosecond adjustment is very fine. Up to

10 nanoseconds of delay may be necessary before you detect a change in the display.

c. Use a Tweeker or other small screwdriver to press the Delay Select button one more time to save the most recent adjustment or allow the 10-second timeout to elapse.

5. If one of the remaining colors is left shifted, repeat steps 3 and 4.

6. Repeat step 1 through 5 for each input.

Chapter3Three

Remote Control

Simple Instruction Set Control

Windows®-Based Program Control

Contact Closure Control

IR 102 Infrared Remote Control

2-18 MTP SW6 • Installation and Operation

Image 18

Contents MTP SW6 Precautions Extron’s Warranty安全须知中文 FCC Class a NoticeTable of Contents Table of Contents, cont’d Appendix a Reference InformationAbout the MTP SW6 Switcher IntroductionRS-232 function Introduction, cont’d Twisted Pair TP Cable Advantages Transmission distanceMTP SW6 Introduction MTP SW6 Introduction, cont’dTabletop use Installation and OperationMounting the Switcher Rack shelf mountingInstallation and Operation, cont’d MTP SW6 Installation and OperationFurniture mounting Installation and Operation, cont’d Connectors and Settings DC power connector Plug the external 12 VDC power supplyInto this 2-pole captive screw connector. See Power supply Power supply wiring Making connectionsRJ-45 Connector TP cable terminationOperation Receiver considerationsSwitch mode Delay Adjust skew adjustment control This controlInstallation and Operation, cont’d Optimizing the Video Level/peaking settingSkew delay compensation Three Simple Instruction Set Control Remote ControlSymbol definitions Host-to-interface communicationsTimeout Remote Control, cont’dError responses Using the command/response tablePeaking adjustment Command/response table for SIS commandsLevel adjustment Input selectionAudio/RS-232 TP input wire pair 3 and 6 configuration Skew adjustmentRS-232 insert enable RemoteLocal audio output volume Audio or RS-232 mute commandsAudio input gain and attenuation SW6 Switch mode SW6 ResetsLock executive modes VX!AX!FX1$VmtX1#AmtX1#ExeX1# Information requestsInstalling the software Windows-Based Program ControlUsing the software Using the help systemRemote Control, cont’d Contact Closure Remote Control IR 102 Infrared Remote ControlSpecifications Reference InformationPart Numbers AccessoriesReference Information, cont’d Included partsCables ConnectorsConnector Part number Enhanced Skew-Free A/V cable Part number