Extron electronic MTP SW6 user manual Reference Information, Specifications

Reference Information

Specifications

Video

Gain Unity

Video input — see MTP Series transmitter specifications

Number/signal type	6 sets of proprietary analog signals
Connectors	6 female RJ-45

Video output — See MTP Series receiver specifications

Number/signal type	1 set of proprietary analog signals
Connectors	1 female RJ-45
Maximum resolution	1920x1200

NRefer to the user's manual for the maximum distances recommended for specific resolutions.

Audio

Number/signal type	1 set of proprietary analog signals
Connectors	1 female RJ-45
Gain	Unbalanced output: 0 dB;
	balanced output: +6 dB
Frequency response	20 Hz to 20 kHz, ±1 dB
THD + Noise	0.15% @ 1 kHz,
	0.3% @ 20 kHz at nominal level
S/N	>70 dB at maximum output (unweighted)
CMRR	>43 dB @ 20 Hz to 20 kHz

Audio input — see MTP Series transmitter specifications

Number/signal type	6 sets of proprietary analog signals
Connectors	6 female RJ-45

N0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu

Audio output — local

Number/signal type	1 dual mono, balanced/unbalanced
Connectors	(1) 3.5 mm captive screw connector, 5 pole
Impedance	50 ohms unbalanced, 100 ohms balanced
Gain error	±1 dB channel to channel

Maximum level (Hi-Z)	>+18 dBu, balanced or unbalanced at
	1% THD+N
Maximum level (600 ohm)	>+15 dBm, balanced or unbalanced at
	1% THD+N

Audio output — see MTP Series receiver specifications

Number/signal type	1 set of proprietary analog signals
Connectors	1 female RJ-45

Control/remote— switcher host control

Serial control port	1 RS-232, 9-pin female D connector
Baud rate and protocol	9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configuration ..	2 = TX, 3 = RX, 5 = GND
Program control	Extron's control/configuration program
	for Windows®
	Extron's Simple Instruction Set (SIS™)

Control/remote — external device (pass-through)

Serial control port	RS-232, 3.5 mm captive screw connector,
	5 pole (uses 3 poles)
Baud rate and protocol	Up to 38400 baud, 5-8 data bits;
	1 or 2 stop bits; odd, even, or no parity;
	XON, XOFF, or no flow control

NProtocol is mirrored between the switcher and the receiver.

Serial control pin configuration .. 1 = TX, 2 = RX, 3 = GND

General

Recommended cable type	CAT5/5E/6 (shielded or unshielded)
External power supply	100 VAC to 240 VAC, 50/60 Hz, external;
	to 12 VDC, 2 A, regulated
Power input requirements	12 VDC, 0.8 A
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) /
	10% to 90%, noncondensing
	Operating: +32 to +122 °F (0 to +50 °C) /
	10% to 90%, noncondensing
Cooling	Convection, vents on both sides

A-2 MTP SW6 • Reference Information MTP SW6 • Reference Information A-3