Extron electronic MTP SW6 user manual Operation, Receiver considerations

Installation and Operation, cont’d

Receiver considerations

NThe receivers' buffered outputs do not provide pre-peaking control. The total recommended distance for an entire daisy chain is the same as for a single transmitter and receiver. The transmitter's Pre-Peak switch has the same affect on the recommended transmission distance for a daisy chain as for a single transmitter and receiver.

NSee the recommended transmission ranges in the table on page 1-5. The recommendations in the table apply equally for the switcher and one receiver and for a transmission daisy chain. For example, the maximum suggested range for high quality transmission of 1024 x 768 video is 600’ between either the switcher and one receiver or the switcher and three daisy-chained receivers.

NFor daisy-chained units, the first receiver in the chain must be at least 100' from the switcher when the Pre-Peak switch is on.

NFor daisy-chained units, any receiver in the chain closer than 350’ may experience some form of over-peaking when the Pre-Peak switch is on.

NIf a receiver is the last receiver in a daisy chain, its end unit DIP switch setting needs to be changed. Refer to the MTP 15HD RS Series manual.

Operation

2

AUTO	1	2	3	INPUT	4	5	6	DELAY
								RED		RGB
SWITCH							SELECT	GREEN
									LEVEL	PEAKING
								BLUE
									ADJUST
	MODE	NORMAL	AUTO

MTP SW6

MTP SWITCHER

1 3 4 5 6 7 8 9 10

Figure 2-10 — Switcher's front panel features

A	Auto Switch LED — When lit, the Auto Switch LED indicates
	that the switcher is in auto switch mode. When unlit, the switch
	is in normal (manual) mode. See "Switch mode" in this chapter.
B	Input Buttons and LEDs — When the auto switch mode is off,
	these buttons select the input. The LED for the selected input
	lights.
	The LEDs continue to indicate the selected input when the auto
	switch mode is on. If no input LED is lit, no input has active
	sync pulses and no input is selected.
	N Front panel input selection cannot be performed when
	the auto switch mode is on (Auto Switch [A] is lit).
C	Mode button — Use this button, with either the Auto or the
	Normal button, to manually turn auto switch mode on or off.
	This control is a secondary function of the Input 1 button.
D	Normal button — Use this button, with the Mode button, to
	manually turn auto switch mode off. This control is a secondary
	function of the Input 2 button.
E	Auto button — Use this button, with the Mode button, to
	manually turn auto switch mode on. This control is a secondary
	function of the Input 3 button.
F	Delay Select button — This recessed button selects the red,
	green, or blue video signal to adjust and resets all three video
	signals to a skew delay of zero nanoseconds.
	Use a Tweeker to press and release this button to select among
	the red, green, or blue video signal to adjust. The selected signal
	is indicated by the Delay Red, Green, and Blue LEDs (G).
	The switcher automatically saves the setting for the video signal
	that is being deselected when you push this button or when the
	selection times out after 10 seconds.
	Press and hold this button for approximately 3 seconds to zero
	the skew delay for red, green, and blue. The Delay Red, Green,
	and Blue LEDS (G) all turn off. Release the button.
G	Delay Red, Green, and Blue LEDs — Indicate the video signal
	that is selected by the Select button (F) for skew adjustment
	using the Adjust control (H). The LED for the selected color
	flashes when the skew compensation for that color’s video
	signal has reached the minimum or maximum limit.

2-12 MTP SW6 • Installation and Operation MTP SW6 • Installation and Operation 2-13