Gigabyte GZ-FSCA1-AN, GZ-FSCA1-SN user manual 8Installation of Built-in HDD Hard Disc Drive

Page 14

English

4-7-3 Refer to the installation order illustrated in the left figure and secure the 3.5” floppy disc drive by controlling the latch. (reverse steps for disassembly)

4-7-4 Installation completed.

4-8Installation of Built-in HDD (Hard Disc Drive)

The 3D AURORA provides built-in bays to accommodate up to 5 hard disc drives (after removal of the tool enclosure). The built-in HDD requires securing runners, which can be found in the black tool enclosure.

Required tool: Securing runners x 10 in the tool enclosure and power extension cables x 2.

4-8-1 Use the runners installed on both sides of the HDD evenly and slide the HDD into the hard disk drive bay.

4-8-2 For installation of the fourth and fifth HDDs, loosen the tool enclosure, and then install the HDD in accordance with Step 4-8-1.

4-8-3 In case the length of power cable is not sufficient for installation of the bottom HDD, it is possible to use the power extension cable inside the tool enclosure, depending on the HDD with 4-pin or SATA power cable.

14

Image 14
Contents 3D Aurora 3D Aurora Introduction Content Components Introduction 1Casing’s Internal StructureFloppy Built-in hard disk 2Front, Rear, and Left Side Panel Structure Features High quality designSpecification Features GZ-FSCA1-AN / GZ-FSCA1-SN2Installation of Motherboard Installation Instruction1Installation of Power Supply 3Installation of Interface Card 4Installation of Front I/O Panel 5Casing’s Internal Structure 6Installation of 5.25 Front Device Bay 7Installation of 3.5 Front Device Bay8Installation of Built-in HDD Hard Disc Drive 9DIY Front Bracket of Projector Light 10Application of Security Lock 11Application of Foot Supports12Liquid cooling System Support 13Recommended Air Cooling/ Liquid CoolingEnglish