Gigabyte GZ-FSCA1-SN, GZ-FSCA1-AN user manual 6Installation of 5.25 Front Device Bay

Page 13

4-6Installation of 5.25” Front Device Bay

The installation of 5.25” CD-ROM is also intended for installation of general 5.25” front device bay. Required tool: None

4-6-1 Open the front panel, remove the 5.25” plastic drive rail and internal metal panel.

4-6-2 Slide the 5.25” CD-ROM into the drive.

4-6-3 Refer to the installation order illustrated in the left figure and secure the 5.25” CD-ROM by controlling the latch (reverse steps for disassembly).

4-6-4 Installation completed.

4-7Installation of 3.5” Front Device Bay

The installation of 3.5” floppy disc drive intended for installation of general 3.5” front device bay Required tool: None

4-7-1 Same as Step 4-6-1.

4-7-2 Slide the 3.5” floppy disc drive into the drive bay.

English

13

Image 13
Contents 3D Aurora 3D Aurora Introduction Content 1Casing’s Internal Structure Components IntroductionFloppy Built-in hard disk 2Front, Rear, and Left Side Panel Structure High quality design FeaturesGZ-FSCA1-AN / GZ-FSCA1-SN Specification Features1Installation of Power Supply Installation Instruction2Installation of Motherboard 3Installation of Interface Card 4Installation of Front I/O Panel 5Casing’s Internal Structure 7Installation of 3.5 Front Device Bay 6Installation of 5.25 Front Device Bay8Installation of Built-in HDD Hard Disc Drive 9DIY Front Bracket of Projector Light 11Application of Foot Supports 10Application of Security Lock13Recommended Air Cooling/ Liquid Cooling 12Liquid cooling System SupportEnglish