Gigabyte AGP 4X(1.5V) IDE Primary Master, Slave / Secondary Master, Slave, Drive a / Drive B

Page 43

)IDE Primary Master, Slave / Secondary Master, Slave

ThecategoryidentifiesthetypesofharddiskfromdriveCtoFthathasbeeninstalledinthe computer.There are two types: auto type, and manual type. Manual type is user-definable; Auto typewhichwillautomaticallydetectHDDtype.

Notethatthespecificationsofyourdrivemustmatchwiththedrivetable. Theharddiskwillnotwork properlyifyouenterimproperinformationforthiscategory.

IfyouselectUser Type,relatedinformationwillbeaskedtoentertothefollowingitems.Enterthe information directly from the keyboard and press <Enter>. Such information should be provided in the documentation form your hard disk vendor or the system manufacturer.

Capacity:

Theharddisksize. The unit is Mega Bytes.

Access Mode:

Theoptionsare: Auto / Large / LBA /Normal.

Cylinder:

The cylinder number of hard disk.

Head

The read / Writeheadnumberofharddisk.

Precomp

Thecylinernumberatwhichthediskdriverchangesthewritecurrent.

Landing Zone

The cylinder number that the disk driver heads(read/write) are seated when the

 

diskdriveisparked.

SECTORS

The sector number of each track define on the hard disk.

If a hard disk has not been installed select NONE and press <Enter>.

)Drive A / Drive B

The category identifies the types of floppy disk drive A or drive B that has been installed in the computer.

None

Nofloppydriveinstalled

360K,5.25“.

5.25 inch PC-type standard drive; 360K byte capacity.

1.2M,5.25”.

5.25inch AT-typehigh-densitydrive;1.2Mbytecapacity

 

(3.5 inch when 3 Mode is Enabled).

720K,3.5“.

3.5 inch double-sided drive; 720K byte capacity

1.44M,3.5“.

3.5inchdouble-sideddrive;1.44Mbytecapacity.

2.88M,3.5“.

3.5inchdouble-sideddrive;2.88Mbytecapacity.

)Floppy 3 Mode Support (for Japan Area)

Disabled

Normal Floppy Drive. (Default value)

Drive A

Enabled 3 mode function of Drive A.

DriveB

Enabled 3 mode function of Drive B.

Both

Drive A & B are 3 mode Floppy Drives.

English

-39-

BIOS Setup

Image 43
Contents Page Page Declaration of Conformity Supplementary Information Declaration of ConformityGA-8PE667 Ultra2 / Pro P4 Titan 667 Motherboard Table of Content Table of Content Installing the motherboard to the chassis… Item ChecklistIntroduction English Bios Ultra2 ProBlock Diagram English Step Hardware Installation ProcessInstall the Central Processing Unit CPU CPU Heat Sink Installation Install memory modules DDR Introduction Install expansion cards Parallel Port and Serial Ports COMA/COMB PS/2 Keyboard and PS/2 Mouse ConnectorUSB/ LAN Connector Audio ConnectorsGame /MIDI Ports IDE3/IDE4 ATX Power FUSB1/FUSB217 WOL 18 SCRAtxpower ATX Power ATX12V +12V Power ConnectorSysfan System FAN Connector Cpufan CPU FAN ConnectorPwrfan Power Fan Connector IDE3 /IDE4 RAID/ATA133,Green Connectorr IDE1/ IDE2IDE1/IDE2 Connector10FDD Floppy Connector SATA1/SATA2 Serial ATA ConnectorFpanel 2x10 pins connector 82XDET 13PWRLEDIrcir 16F USB1 / FUSB2Front USB Connector, Yellow17WOL Wake On Lan SCR Smart Card Reader Header,Black ConnectorSpdifo SPDIFOut Cdin CD IN,Blank Faudio Faudio ConnectorAuxin AUX In Connector CI Case Open Battery Battery English Bios Setup Main Menu For example Bios Ver. F1 Load Optimized Defaults Power Management SetupPnP/PCI Configurations Load Fail-Safe DefaultsDate Standard Cmos FeaturesTime IDE Primary Master, Slave / Secondary Master, Slave Floppy 3 Mode Support for Japan AreaDrive a / Drive B Extended Memory Halt onMemory Base MemoryFirst / Second / Third Boot device Advanced Bios FeaturesInit Display First Boot Up Floppy SeekPassword Check CPU Hyper-ThreadingATA Integrated PeripheralsIDE2 Conductor Cable On-Chip Primary PCI IDEOn-Chip Secondary PCI IDE IDE1 Conductor CableSerial ATA Function USB Mouse SupportAC97 Audio Onboard H/W SataUart Mode Select Onboard LAN Boot ROMOnboard Serial Port OnBoard Parallel port Parallel Port ModeCIR Port IRQ CIR Port AddressPower Management Setup Power Management SetupPME Event Wake up Power LED in S1 StateAcpi Suspend Type Soft-off by PWR-BTTNKB Power on Password Resume by AlarmPower On By Mouse Power On By KeyboardPCI3 IRQ Assignment PnP/PCI ConfigurationsPCI1/PCI5 IRQ Assignment PCI2/PCI6 IRQ AssignmentPC Health Status Reset Case Open Status Case OpenedCurrent Voltage V Vcore /+1.5V/+3.3V/ +5V / +12V Fan Fail Warning CPU / Power / System Current CPU Temperature CCurrent CPU FAN / Power / System FAN Speed RPM CPU Warning TemperatureCPU Clock Ratio Frequency/Voltage ControlCPU Host Clock Control Memory FrequencyMhz CPU Host Frequency MHzFixed PCI/AGP Frequency Host/DRAM Clock RatioTop Performance Top PerformanceSelect Language ` Load Fail-Safe Defaults? Y/N?N Load Fail-Safe DefaultsLoad Optimized Defaults? Y/N?N Load Optimized DefaultsEnter Password Set Supervisor/User PasswordExit Y/N? Y Save & Exit SetupQuit Without Saving Y/N? N Exit Without SavingEnglish Technical Reference Easy TuneTM 4 Introduction Face-Wizard Utilities Installation Bios Flash Procedure English English English English Integrated Peripherals Save to Cmos and Exit Y/N? Y COMMAND.COM 7VTX.F4 EXIT? Load Setup Defaults? Y/N?N Congratulate you have accomplished the Bios flash procedure What is Dual Bios Technology? Wide Range Protection DisabledDefault, Enabled Bios Recovery Main to Backup DualBIOSTM Technology FAQ What is DualBIOSTM technology? Answer III. Q How does DualBIOSTM technology work? Answer English English English 6-Channel Audio Function Introuction Channel Analog Audio Output Mode Basic 6 Channel Analog Audio Output Mode Step Connect the SURROUND-KIT to Surcen on Basic & Advanced 6 Channel Analog Audio Output ModeNotes Spdif Output Device Optional Device English Appendix Item Description Software Application Software Information Contact US Acronyms Ioapic Technical Support/RMA Sheet Troubleshooting 104 Memo 106 107 108