Gigabyte GA-K8NF-9 user manual Yes

English

Step 5:

Next, select the hard drives which you wish to be included in the disk array. The Free Disks section displays the information about the currently installed SATA hard drives. Press the TAB key to move to the Free Disks section. Select the target hard drives using the UP or DOWN ARROW key and use the RIGHT ARROW key to add the hard drives to the Array Disks section (Figure 7).

MediaShield RAID Utility Feb 8 2005

- Define a New Array -

RAID Mode: Striping		Striping Block: Optimal
Free Disks		Array Disks
Loc	Disk Model Name	Loc	Disk Model Name
		1.0.M	ST3120026AS

[	] Add 1.1.M	ST3120026AS
[	] Del
[ESC] Quit [F6] Back [F7] Finish	[TAB] Navigate	[ ] Select [ENTER] Popup

Figure 7

Step 6:

Press F7 after selecting the target hard disks. A message which says "Clear disk data?" will appear (Figure 8). If you are sure to clear the data in the selected hard drives, press Y. (If the hard drives contain previously created RAID array, you need to press Y to clear the data from the hard drives.)

MediaShield RAID Utility Feb 8 2005

- Define a New Array -

RAID Mode: Striping					Striping Block: Optimal
Free Disks					Array Disks
Loc	Disk Model Name				Loc	Disk Model Name
			Clear disk data ?			ST3120026AS
					1.0.M
			[	] Add	1.1.M	ST3120026AS
			[Y] YES		[N] NO
			[	] Del
	[ESC] Quit	[F6]	Back [F7] Finish	[TAB] Navigate		[ ] Select [ENTER] Popup

Figure 8

GA-K8NF-9(rev. 2.2) Motherboard - 70 -