ATTO Technology 2100, 3100, 3200, 2200, 1100 manual Connection pages

Page 13

utilities. Upon exiting BridgeTools, the COM port will return to its previous setting.

To connect to the FibreBridge, select the appropriate COM port. If no choices are available, the bios or operating system may not be configured for a serial port. Refer to your computer or OS manuals for instructions. Once this is done, configure the remaining serial port settings.

The default values for the FibreBridge are:

Baud Rate = 9600

Data Bits = 8

Parity = None

Stop Bits = 1

Flow Control = None

If a link cannot be established, BridgeTools will time out and an error message will be displayed. If this happens, verify the following items:

The FibreBridge(s) is powered up

Cables have a secure connection. Make sure a crossover serial cable is being used.

The COM port on the computer is configured properly.

Hyperlink or some other serial program is able to communicate between the FibreBridge and the computer.

Connection pages

10

Image 13
Contents Installation & Operations Manual Page Contents Atto FibreBridge supports diverse SAN needs FibreBridge family Atto FibreBridgeTM feature availability matrix1180E/D 1190E 2200R/D 2300E/R/D 3200R 3300R 4500C/R/D BridgeTools aids FibreBridge management Term Definition GlossaryInstallation step by step Installing the BridgeTools programRequirements Sun Solaris Installing the programGraphical Interface BridgeTools graphical interface is readyStarting up Welcome FibreBridge connection pagesEthernet connection Serial port connectionConnection pages General panel Scsi Port configuration panel Ethernet port configuration panel Baud Rate default = Serial port configuration panelFlow Control default = None Stop Bits default =Firmware updater panel Fibre Channel port configuration panel Fibre Channel Frame Length default = Fibre Channel Connect Mode default = Arbitrated Loop FLPortOpen Full Duplex default = Enabled Physical Device Addressing Method default = Llll TttbFC port configuration Mapping panel Mapping Trouble shootingEvent Logging default = active Event Level default = all activeEvent Subsystem default = all active Events panelSave/Restore panel Embedded Appendix a Available products and accessoriesDestop/Rackmount Atto FC Rack System build to orderField Replacement Units FRU Atto Technology, Inc Appendix B How to contact Atto Technology, Inc