ATTO Technology 2100, 3100, 3200, 2200, 1100 manual Mapping, Trouble shooting

Page 23

Trouble shooting

The mapping panel is also very useful for troubleshooting. Clicking the SCAN button displays a list of the Fibre Channel port(s) and the SCSI Target devices, as well their status (online/offline).

If a target is not detected or is listed as offline in the STATUS field, check the device itself, the SCSI cabling, and the SCSI termination.

If all targets for a particular SCSI Bus are not detected or are all listed as offline in the STATUS field, chances are the SCSI Bus within the bridge itself has failed. Call the place of purchase for a repair order.

If a Fibre Port is listed as offline in the STATUS field, chances are the Fibre Port within the bridge itself has failed. Call the place of purchase for a repair order.

Mapping

Some options will be “grayed out” on the panel: they are not available because of the type of access mode or FibreBridge model or they have no effect based on other

selections. The chart below shows options available based on model and access method.

Model/Access method

2200/3200

2200/3200

2200/3200

4500

4500

4500

Options

in-band

Ethernet

serial port

in-band

Ethernet

serial port

 

 

 

 

 

 

 

Mapping Panel

 

 

 

 

 

 

 

 

 

20

Image 23
Contents Installation & Operations Manual Page Contents Atto FibreBridge supports diverse SAN needs 1180E/D 1190E 2200R/D 2300E/R/D 3200R 3300R 4500C/R/D Atto FibreBridgeTM feature availability matrixFibreBridge family BridgeTools aids FibreBridge management Term Definition GlossaryRequirements Installing the BridgeTools programInstallation step by step Sun Solaris Installing the programGraphical Interface BridgeTools graphical interface is readyStarting up Serial port connection FibreBridge connection pagesWelcome Ethernet connectionConnection pages General panel Scsi Port configuration panel Ethernet port configuration panel Stop Bits default = Serial port configuration panelBaud Rate default = Flow Control default = NoneFirmware updater panel Fibre Channel port configuration panel Physical Device Addressing Method default = Llll Tttb Fibre Channel Connect Mode default = Arbitrated Loop FLPortFibre Channel Frame Length default = Open Full Duplex default = EnabledFC port configuration Mapping panel Mapping Trouble shootingEvents panel Event Level default = all activeEvent Logging default = active Event Subsystem default = all activeSave/Restore panel Atto FC Rack System build to order Appendix a Available products and accessoriesEmbedded Destop/RackmountField Replacement Units FRU Atto Technology, Inc Appendix B How to contact Atto Technology, Inc