4.10 Save/Restore panel
This panel saves the new configuration changes in FibreBridge NVRAM, restores values to the factory defaults, or exits without saving the changes.
CAUTION New settings and newly flashed firmware will not take affect until the FibreBridge power is cycled.
Leave This Session
Closes the current connection with the FibreBridge and exits BridgeTools. Changed parameters during this session will not take effect unless they were saved before closing the connection.
Make Use of Saved Changes
Issues a restart firmware command to the FibreBridge. This is the same as cycling power on the FibreBridge. Any freshly saved configuration parameters or new firmware will now be in effect.
Save Current Settings
Saves any changes made to the configuration parameters. The FibreBridge will use these options the next time it is powered up.
Set to Factory Defaults
Sets configuration settings to the factory defaults.
Undo Changes
Ignores any changes made since entering the BridgeTools program and returns configurations to the last saved values.
Some options will be “grayed out” on the panel: they are not available because of the type of access mode or FibreBridge model or they have no effect based on other
selections. The chart below shows options available based on model and access method.
Model/access method | 2200/3200 | 2200/3200 | 2200/3200 | 4500 | 4500 | 4500 |
Options | Ethernet | serial port | Ethernet | serial port | ||
|
|
|
|
|
|
|
Leave this session | ● | ● | ● | ● | ● | ● |
|
|
|
|
|
|
|
Make use of saved changes |
| ● | ● |
| ● | ● |
|
|
|
|
|
|
|
Save current settings | ● | ● | ● | ● | ● | ● |
|
|
|
|
|
|
|
Set to factory defaults | ● | ● | ● | ● | ● | ● |
|
|
|
|
|
|
|
Undo changes | ● | ● | ● | ● | ● | ● |
|
|
|
|
|
|
|
22