ATTO Technology 1100, 3100, 3200 Events panel, Clear all Events, Event Level default = all active

Page 24

4.9 Events panel

Event logs help to troubleshoot hardware failures. This panel configures the event logging features of the FibreBridge. Some parameters will be “grayed out” if they do not apply to your model of the FibreBridge or if they have no effect based upon the selected value of a related parameter.

If the SAN is unable to detect or communicate with SCSI devices connected to the FibreBridge, you can examine the Event Log to determine if there is a hardware issue with the FibreBridge or if the problem is due to a configuration error. If the FibreBridge is configured to log all events, the log can be lengthy and difficult to interpret. Log events as efficiently as possible by enabling logging for that section of the FibreBridge.

Use BridgeTools to configure the type of event logging desired. To view the actual events, use either Serial or Ethernet communications tools such as FTP or Hyper Terminal. Refer to the FibreBridge manual for further details.

Clear all Events

Erases all previously recorded event log entries.

Event Level (default = all active)

Selects the level of monitoring and logging.

Event Logging (default = active)

Disables Event logging.

Event Subsystem (default = all active)

Selects which hardware subsystems are to be monitored. Select as many of the hardware systems as needed:

Fibre Channel

SCSI, Ethernet

GBIC

NVRAM hardware systems

Some options will be “grayed out” on the panel: they are not available because of the type of access mode or FibreBridge model or they have no effect based on other

selections. The chart below shows options available based on model and access method.

Access method

2200/3200

2200/3200

2200/3200

4500

4500

4500

Options

in-band

Ethernet

serial port

in-band

Ethernet

serial port

 

 

 

 

 

 

 

Clear All Events

 

 

 

 

 

 

 

 

 

Event Level

 

 

 

 

 

 

 

 

 

Event Logging

 

 

 

 

 

 

 

 

 

Event Subsystem

 

 

 

 

 

 

 

 

 

21 ATTO Technology BridgeTools Installation and Operation Manual

Image 24
Contents Installation & Operations Manual Page Contents Atto FibreBridge supports diverse SAN needs Atto FibreBridgeTM feature availability matrix FibreBridge family1180E/D 1190E 2200R/D 2300E/R/D 3200R 3300R 4500C/R/D BridgeTools aids FibreBridge management Glossary Term DefinitionInstalling the BridgeTools program Installation step by stepRequirements Installing the program Sun SolarisBridgeTools graphical interface is ready Graphical InterfaceStarting up FibreBridge connection pages WelcomeEthernet connection Serial port connectionConnection pages General panel Scsi Port configuration panel Ethernet port configuration panel Serial port configuration panel Baud Rate default =Flow Control default = None Stop Bits default =Firmware updater panel Fibre Channel port configuration panel Fibre Channel Connect Mode default = Arbitrated Loop FLPort Fibre Channel Frame Length default =Open Full Duplex default = Enabled Physical Device Addressing Method default = Llll TttbFC port configuration Mapping panel Trouble shooting MappingEvent Level default = all active Event Logging default = activeEvent Subsystem default = all active Events panelSave/Restore panel Appendix a Available products and accessories EmbeddedDestop/Rackmount Atto FC Rack System build to orderField Replacement Units FRU Appendix B How to contact Atto Technology, Inc Atto Technology, Inc