ATTO Technology FC 3321, FC 3322, FC 3342 operation manual Appendix a Standards and compliances

Page 20

Appendix A Standards and compliances

The equipment described in this manual generates and uses radio frequency energy. The Technical Specification sheet for a particular ATTO ExpressPCI host bus adapter list certifications for that model.

FCC standards: radio and television interference

WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Consult the dealer or an experienced radio/TV technician for help

Canadian standards

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

European standards

Declaration of Conformity

This following statement applies to the ATTO Express PCI host bus adapter.

This device has been tested in the basic operating configuration and found to be compliant with the following European Union standards:

Application of Council Directive: 89/336/EEC

Standard(s) to which conformity is declared: EN55024:1998

This Declaration will only be valid when this product is used in conjunction with other CE approved devices and when the entire system is tested to the applicable CE standards and found to be compliant.

Usage restrictions

The use of optical instruments with this product will increase eye hazard.

The multimode transceiver is a Class 1 laser product complying with IEC 825-1 and FDA-21 CFR 1040.11. To meet laser safety requirements, the transceiver shall be operated within the maximum ratings. The laser is non-OFC compliant as it is a Class 1 device.

The optical ports of the modules must be terminated with an optical connector or with a dust plug.

CAUTION Failure to adhere to the above restrictions could result in a modification that is considered an act of “manufacturing” and will require, under law, recertification of the modified product with the U.S. Food and Drug Administration (ref. 21 CFR 1040.10(i)).

iATTO Technology ExpressPCI FC 3321, 3322 and 3342 Installation and Operation Manual

Image 20
Contents Atto Technology, Inc Atto ExpressPCI FC Page Contents Page Page Atto provides Fibre Channel solutions Atto ExpressPCI FCFeatures and benefits Exclusive Advanced Data Streaming ADS TechnologyAmps max @ 3.3 Volts max Amps max @ 5 Volts max Fibre Channel host adapter selection guide Fibre Channel is a key technology for storage GlossaryGlossary Fibre Channel address Hardware installation and initial configurationSystem requirements Installation ExpressPCI FC LEDsCabling ExpressPCI FC 3321 bracket and boardExpressPCI FC 3322 bracket and board Initial configuration Installing/updating device drivers and firmware Windows 2000/XP driver installationDevice drivers Windows NT TroubleshootingGeneral suggestions Troubleshooting Appendix a Standards and compliances FCC standards radio and television interferenceCanadian standards European standardsAppendix B Fibre Channel accessories Specific features Appendix C Scsi host adapter selection guideAppendix D Contact Atto Technology, Inc