ATTO Technology FC 3321, FC 3322, FC 3342 Amps max @ 3.3 Volts max Amps max @ 5 Volts max

Page 8

ATTO ExpressPCI FC 3342

The ATTO ExpressPCI FC 3342 host adapter, with four independent 2-Gigabit FC ports and delivering data-transfer rates up to 400 MB/second per channel, provides the ultimate performance for the most demanding data environments. It is ideal for connecting servers directly to multiple storage sub-systems for advanced, aggregated performance, while still conserving valuable PCI expansion slots. It supports high-performance applications, including Digital Video/Audio, Imaging/Fixed Content and Backup/Archiving.

Fibre Channel Interface

2.125-Gigabit data-transfer rates on each channel

400 MB/sec. per channel, full duplex

Auto negotiation between 1-Gigabit and 2-Gigabit speeds

Short-wave optical LC SFP connectors

Supports all Fibre Channel topologies

Point to Point

Arbitrated loop

Switched fabric (FL-port, F-port)

Strict adherence to ANSI specifications: FC-PH, FC-AL2, FC-FCP, FC-PLDA, FC-FLA, FCA-IP, iETF-iPFC, FC-Tape

Supports Class 2 and Class 3 transfers

LEDs indicate link activity, on line and fault status for each channel

Flash ROM for easy field upgrades

Advanced FC Features

Support for SNIA HBA API

LUN Masking

Supports target and initiator modes

Advanced SCSI-FCP Support

Large command FIFO

Asynchronous I/O support

ASPI compatible

Bootable from attached disks

Support for multiple block sizes

Exclusive Advanced Data Streaming (ADS™) Technology

Improved PCI system bandwidth use

Optimized FC and SCSI-3 algorithms

Supports SCSI-3 tagged command queuing

RISC processor for high performance

Accelerated PCI Bus Management

PCI bus master DMA

PCI 2.2 and PCI 99 compliant

64-bit/133 MHz PCI-X

Environmental & Physical Specifications

Temperature:0-50ºC

Humidity:5-90% non-condensing

Low-profile dimensions:

Height: 4.2"

Width: 6.875"

MTBF:>100,000 hours

MTTR:<15 minutes

Airflow:100 LFM (min)

Power Requirements:

1.0Amps max @ 3.3 Volts (max)

4.5Amps max @ 5 Volts (max)

PCI Signal Compatibility:

3.3Volts only

3

Image 8
Contents Atto Technology, Inc Atto ExpressPCI FC Page Contents Page Page Atto provides Fibre Channel solutions Atto ExpressPCI FCFeatures and benefits Exclusive Advanced Data Streaming ADS TechnologyAmps max @ 3.3 Volts max Amps max @ 5 Volts max Fibre Channel host adapter selection guide Fibre Channel is a key technology for storage GlossaryGlossary Fibre Channel address Hardware installation and initial configurationSystem requirements Installation ExpressPCI FC LEDsCabling ExpressPCI FC 3321 bracket and boardExpressPCI FC 3322 bracket and board Initial configuration Installing/updating device drivers and firmware Windows 2000/XP driver installationDevice drivers Windows NT TroubleshootingGeneral suggestions Troubleshooting Appendix a Standards and compliances FCC standards radio and television interferenceCanadian standards European standardsAppendix B Fibre Channel accessories Specific features Appendix C Scsi host adapter selection guideAppendix D Contact Atto Technology, Inc