Tripp Lite 2-9USTAND owner manual Installation, Post Mounting, Mounting Rack

Page 3
Mounting Rack

Installation

Mounting Rack

Mount your equipment in either a 4-post or 2-post rack or rack enclosure (see next page for 2-post mounting). The user must determine the fitness of hardware and procedures before mounting. If hardware and procedures are not suitable for your application, contact the manufacturer of your rack or rack enclosure. The procedures described in this manual are for common rack and rack enclosure types and may not be appropriate for all applications.

4-Post Mounting

All UPS models include hardware required to mount in a 4-post rack. Select models include an adjustable rackmount shelf kit to provide additional support. If your UPS model does not include an adjustable rackmount shelf kit, skip steps 1 and 2.

1Connect the two segments of each shelf A using the included screws and nuts B . Leave the screws slightly loose so that the shelves can be adjusted in the next step.

2Adjust each shelf to fit your rack, then mount them in the lowest available space of your rack with the screws, nuts and washers provided C . Note that the support ledges should face inward. Tighten the screws that connect the shelf segments B .

3Attach mounting ears D to the front mounting holes of your equipment E using the screws provided F . The ears should face forward.

4Using an assistant if necessary, lift your equipment and slide it onto the mounting shelves. Attach your equipment to the rack by using the appropriate hardware G through its mounting ears and into the rack rails.

B

A

1

C

2

B

 

E

 

D

F

3

 

G

 

4

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Battery Replacement Important Safety InstructionsInstallation TroubleshootingUPS Connection Warnings Battery WarningsSAVE THESE INSTRUCTIONS UPS Location WarningsMounting Rack 4-Post MountingInstallation continued 2-Post Telecom MountingMounting Tower 3 Turn your UPS ON InstallationImporant continuedSafety Instructions1 Plug your UPS’s line cord into an electrical outlet 2 Plug your equipment into your UPS3 EPO Port Connection all models 4 External Battery Connection2 USB and RS-232 Serial Communications all modelsUPS Cold Start UPS Power ONAlarm Silence UPS Self-TestFront Panel Indicator Lights continued Basic Operation continuedExternal Battery Pack Connector configuration varies by model Use to connect optional Tripp Lite Battery Packs for additional runtime. Contact Tripp Lite Customer Support at 773 869-1234 for the appropriate Tripp Lite battery pack to connect. Refer to instructions available with the Battery Pack for complete connection information and safety warnings Rear Panel continued Communicationsapplications Troubleshooting or low for the UPS to operate in BYPASS Troubleshooting continuedThis indicates that utility power is too high adequate space for air to circulate near6 Replace Front Panel Procedure1 Remove Front Panel 2 Disconnect Batteries 3 Remove/Dispose of Batteries 4 Add Batteries 5 Connect BatteriesStorage Service1111 W. 35th Street, Chicago, IL 60609 USA 773.869.1234 USA 773.869.1212 International200811139 93-2471EN
Top Page Image Contents