7. Administration (continued)
7.1.4Local Console Firmware Upgrade (continued)
Firmware Upgrade Recovery
In the event of a firmware upgrade failure, or an aborted firmware upgrade, perform a firmware upgrade recovery by doing the following:
1.Power OFF the switch. If it is part of a daisy chain, disconnect it from the chain.
2.Connect the firmware upgrade cable to the firmware upgrade port.
3.Slide the Firmware Upgrade Recovery Switch to the Recover position.
4.Power the switch back ON and repeat the upgrade procedure.
5.After the switch has been successfully upgraded, power it OFF and then slide the Firmware Upgrade Recovery Switch back to the Normal position.
6.If the switch is part of a daisy chain, reconnect it to the daisy chain.
7.Power the switch back ON.
7.2 Remote OSD
Upon logging into the KVM over IP, you are connected to the first connected computer on the installation that you have access to, and the Remote OSD appears with the Main tab displayed. (See diagram). Administrators have access to all features in the OSD, whereas Users only have access to the Main tab and Configuration tab. The administrative settings of the Remote OSD are described in the following section.
7.2.1 Remote OSD List
Just like the F2 LIST function in the local console OSD, the remote OSD allows you to determine which ports are listed on the Main tab. Simply click on the
Setting | Description |
|
|
ALL | Lists all of the ports on the installation that |
| are accessible to the |
| whether they are |
|
|
POWERED ON | Lists all of the ports on the installation that |
| are both accessible to the |
| and |
|
|
QVIEW | Lists all of the ports on the installation that |
| are set as Quick View ports by an |
| administrator. |
|
|
QVIEW + POWERED ON | Lists all of the ports on the installation that |
| are both set as Quick View ports by an |
| administrator and are powered ON. |
|
|
30