Q-Logic QLA12160 manual Table A-1. Host Adapter Settings

Page 18

Configuration Settings

A – Fast!UTIL

A.2.1

Host Adapter Settings

From the Configuration Settings menu in Fast!UTIL, select Host Adapter Settings. Default settings for the QLA12160 host adapter board are listed in table A-1and described in the following paragraphs.

Table A-1. Host Adapter Settings

Setting

Options

Default

 

 

 

Host adapterBIOS

Enabled, Disabled

Enabled

PCI bus DMA burst

Enabled, Disabled

Enabled

CDROM Boot

Enabled, Disabled

Disabled

Adapter Configuration

Auto, Manual, Safe

Auto

Drivers load RISC code

Enabled, Disabled

Enabled

>4 Gbyte Addressing

Enabled, Disabled

Disabled

Fast Command Posting

Enabled, Disabled

Enabled

 

 

 

Host adapter BIOS. When this setting is Disabled, the ROM BIOS on the QLA12160 board is disabled, freeing space in upper memory. The RAM BIOS and other drivers still recognize the QLA12160 board. Do not disable this setting when you are booting from a SCSI disk drive attached to the QLA12160 board. The default is Enabled (ROM BIOS on the QLA12160 board is enabled).

PCI bus DMA burst. When this setting is Enabled, burst transfers are performed. When this setting is Disabled, data is transferred in nonburst mode, with each cycle initiated by a new address phase. The default is Enabled.

CDROM Boot. When this setting is Enabled, the ROM BIOS boots from the attached SCSI CD-ROM when a bootable compact disk is installed. If no bootable CD-ROM is found, the system boots from the first bootable SCSI drive. When this setting is disabled, the ROM BIOS does not boot from the CD-ROM. The default is Disabled.

Adapter Configuration

Auto. The ROM BIOS automatically configures the QLA12160 board to match any SCSI device attached to the board and selects optimum performance. The default is Auto.

Manual. You can control the configuration settings for each SCSI device and have the option of running Autoconfigure. See section A.2.4 to have Fast!UTIL configure the devices.

NOTE: Changing any value can cause performance problems or incorrect device operation.

A-2

DC8151101-00 C

Image 18
Contents Hardware Installation Guide for QLA12160 Board QLogic Corporation Table of Contents Figures Introduction Product DescriptionScsi Data Transfer Rates Features Mixed Peripheral Support Features Hardware Installation Preinstallation ProceduresWhat You Need for Installation Setting the Scsi Termination Scsi Termination PowerInstalling the Device Activity Light Installation in the Computer Number Installation Help Installation Help Hardware Problem Checklist TroubleshootingProblems After Installation System Configuration Problem ChecklistScsi Problem Checklist Maximum Cable LengthConfiguration Settings IntroductionHost Adapter Settings Table A-1. Host Adapter SettingsScsi Device Settings Table A-2. Scsi Device SettingsEnable Device Scsi Bus Settings Table A-3. Scsi Bus SettingsScsi termination Table A-4. QLA12160 PortsAutoconfigure Scsi Devices Selectable Boot SettingsRaw Nvram Data Restore Default SettingsUsing SCSI-1 Devices Scan Scsi BusFast!UTIL Using SCSI-1 Devices Using SCSI-1 Devices Fast!UTIL DC8151101-00 C Scsi Termination Termination Jumpers for the QLA12160Figure B-1. QLA12160 Jumper Termination Specifications Table C-2. QLA12160 Board SpecificationsTable C-1. QLA12160 Board Operating Environment Specifications