Tape Operations
Tape selection repeat
The tape selection repeat continuously plays the current track.This function continues automatically until it is canceled.
1.Press RPT button 6. “RPT” lights in the dis- play and the current track is repeated.
2.To cancel the repeat play, press RPT button
6 again. “RPT” goes off from the display and normal play resumes.
Blank tape skip
The blank tape skip allows you to skip blank sec- tions of tape that are over 12 seconds long.
1.Press and hold RPT button 6 for 1 second or longer. “BLS” lights in the display and the mechanism fastforward to the next track se- lection.
2.To cancel the blank tape skip, press and hold RPT button 6 for 1 second or longer again. “BLS” goes off from the display and normal play resumes.
Notes:
The APC, intro tape scan, tape selection repeat and blank skip may not work properly with tapes of the following qualities:
•Tapes on which the recording level is too low.
•Tapes on which there is much noise between se- lections.
•Tapes on which there are long pauses in the middle of selections.
•Tapes on which there are less than 4 seconds of blank space between selections.
Other Handy Functions
Setting the clock
1.Press and hold ADJ button 4 for 1 second or longer to switch to the adjustment selection display.
2.Press the right or left side of SEARCH button $ to select “CLOCK”.
3.Press ENT button 2.
4.Press the right or left side of SEARCH button $ to select the hour or the minute.
5.Turn the Rotary knob % clockwise or coun- terclockwise to set the correct time.
∗ The clock is displayed in
6.Press ENT button 2 to store the time into memory.
7.Press ADJ button 4 to return to the previous mode.
Note:
•You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the car’s battery or take out this unit, the clock is reset. While setting the clock, if another button or operation is selected, the clock set mode is canceled.
Dimmer level setting
You can reduce the display illumination linked to the car illumination.
∗The factory default setting is “LEVEL 3”.
1.Press and hold ADJ button 4 for 1 second or longer to switch to the adjustment selection display.
2.Press the right or left side of SEARCH button $ to select “DIMMER LV”.
3.Press ENT button 2.
4.Turn the Rotary knob % clockwise or coun- terclockwise to set the dimmer level. Choose the dimmer level from the following.
“OFF”, “LEVEL 1”, “LEVEL 2”, “LEVEL 3”, “LEVEL 4”, “LEVEL 5”.
LEVEL 1 to LEVEL 5:
The greater the dimmer level is, the more the illumination is reduced.
OFF:
Even if the car illumination is turned on, re- duction of the display illumination does not occur.
5.Pressing ENT button 2 returns to the adjust- ment selection display.
6.Press ADJ button 4 to return to the previous mode.
16 ARX8570z
