Q-Logic 3100, 3000 QLogic Adapter Flash Update-Linux, Table B-2. Flash Utility Commands-Linux

B–Flash Update

QLogic Adapter Flash Update—Linux

To perform updates simultaneously from two different directory trees, type the following commands from two separate directory trees. In these commands, n represents two different port numbers, for example, “Local Area Connection 4” and “Local Area Connection 5” (the quotation marks are required).

c:\[version]-a\utils\ nxflash.exe -i “Local Area Connection n” --all (first QLogic adapter)

c:\[version]-b\utils\ nxflash.exe -i “Local Area Connection n” --all (second QLogic adapter)

QLogic Adapter Flash Update—Linux

This section describes how to perform a Flash update in Linux. Note that the QLogic adapter is shipped with a default Flash version.

Using the Flash Utility

When invoking the nxflash utility, use the following syntax:

% ./nxflash -i [n] [command]

In this command, the [n] indicates the QLogic adapter device number (0, 1, etc.). Along with the interface type (-iin the nxflash command syntax), additional commands ([command] in the nxflash command syntax) are listed in

Table B-2.

Table B-2. Flash Utility Commands—Linux

Command	Definition	Description
-l	List devices	This command shows all QLogic devices
--list		installed.
-i	Interface	This command specifies the interface type
--interface		(0, 1, 2, etc.).
--info	Information	This command displays adapter informa-
		tion such as the adapter type, chip revision,
		serial ID, firmware version, BIOS version,
		MAC address, etc.
-a	Flash update	This command performs a complete
--all		update of the BIOS and the firmware. This
		command is used when the default ROM
		image is used.

B-8 NE0154601-00 C