Moxa Technologies 6110 user manual Modbus Serial Settings

Page 38

Modbus Serial Settings

The Modbus Serial Settings page is used to configure NPort 6110’s DB9 Male port. You can configure Interface Mode, Baud Rate, Parity, Data Bits, Stop Bit, Flow Control, and UART FIFO.

NOTE To modify the settings on this page, you must first checkmark the Change Modbus Settings box at the top of the Modbus Settings page.

4-12

Image 38

Contents NPort 6110 Modbus/TCP To Serial Communication Gateway Page NPort 6110 Modbus/TCP To Serial Communication Gateway Page Moxa Internet Services Page Table of Contents Page Introduction OverviewFeatures Powerful operation modes for versatile Modbus applicationsProduct Specifications LANPackage Checklist EnvironmentalFront/Top/Rear/Bottom Panel Views Page Getting Started Power ConnectionSerial Installation Ethernet Installation Software InstallationPage Page Page Page Housing DIN-RailWall Mount Typical Modbus Applications Connect all Modbus devices over the Ethernet network… Link the Serial Master device with Ethernet Slave devices… Page Configuring Modbus Gateway Starting Modbus Gateway Configurator Specify by IP Address Searching for NPortBroadcast Search Modify Configuration Network Settings Modbus Settings AlphanumericPage Page Advanced Modbus Settings IP address Page Modbus Serial Settings RTS/CTS Uart Fifo Password Unlock Upgrade FirmwareOther Functions Page Remote Monitoring and Management Start Log MonitorPage Troubleshooting ID No. mismatchPage Pin Assignments DB9 Male PinoutsPage Declaration of Conformity Page Problem Report Form NPort 6110 Modbus GatewayReturn Procedure