Pelco manual Connect all cables refer to Figure, Close and latch the EW5001 to the J-box

Page 23

10.Connect all cables (refer to Figure 17):

NOTE: Be sure to fully seat each connector. Otherwise, environmental protection may fail, causing the unit to fail.

WEATHERPROOF NETWORK

CONNECTOR (SUPPLIED)

WEATHERPROOF NETWORK

CABLE (NOT SUPPLIED)

POWER CABLE

(SUPPLIED)

Figure 17. Connecting Cables to the EW5001

a.If installing a power cable: Connect the power cable connector.

(1)Remove the protective cover from the power connector on the rear panel.

(2)Connect the power cable to the power connector on the rear panel. The connector is keyed and only attaches one way. Make sure you twist the connector all the way down.

b.Connect the weatherproof network connector.

NOTE: The supplied weatherproof network connector must be installed before you continue. To install the connector, refer to the

appropriate section: Separate Power and Network Cables on page 13 or Power-over-Ethernet (PoE) on page 16.

(1)Remove the protective cover from the network connector on the rear panel.

(2)Connect the weatherproof network connector to the network connector on the rear panel. The connector is keyed and only attaches one way. Make sure you twist the connector all the way down.

c.If using an integrated antenna: Check the antenna connector to make sure it is fully seated. When inserting the connector, you should hear or feel two clicks.

d.If using a separate antenna: Connect the antenna cable.

(1)Make sure the frequency of the antenna matches the frequency of the EW5001. A label is attached to the antenna connector; the blue label is for 2.4 GHz, the red label is for 5.8 GHz.

(2)Make sure the antenna cable is the correct length (refer to Optional Accessories on page 5).

(3)Remove the protective cover from the antenna connector on the rear panel.

(4)Connect one end of the antenna cable to the antenna. Connect the other end of the cable to the connector on the rear panel. Make sure both connectors are fully seated. When inserting the connector, you should hear or feel two clicks.

11.Close and latch the EW5001 to the J-box.

C2681M (2/08)

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Endura EW5001 Wireless Access Point/Bridge Contents List of Tables List of IllustrationsExposure to Radio Frequency Fields Regulatory NoticesVideo Quality Caution Models Optional AccessoriesDescription Qty Description Parts ListBefore You Begin USER-SUPPLIED PartsPackage Contents Application Scenarios Sample EW5001 Access Point Application ScenarioSample EW5001 Wireless Bridge Application Scenario IP-TYPE Camera Systems Product Serial Number Label Product Serial Number Label PlacementMount Description Required Adapter Maximum Load Mount InstallationSite Preparation Site Selection12 VDC 24 VAC Power and Network WiringMaximum Distance AC+ Wire ColorTo install the network cable refer to on POWER-OVER-ETHERNET POE Ferrule Bench Setup Optional Antenna InstallationUnit Installation NUT Lock Washer Weatherproof Network Cable not Supplied Power from Source C2681M 2/08 Close and latch the EW5001 to the J-box Connect all cables refer to FigureOpening the J-BOX Disconnecting AN Antenna CableOperation IndicatorsStartup Phase Unit Antenna AlignmentStatus Change Rssi Volts Rssi dBConfiguration Problem Possible Causes Suggested Remedy TroubleshootingSpecifications Esprit pole mount with center feedthrough hole ECM100 Esprit corner mount with center feedthrough holeProduct Warranty and Return Information ISO9001
Related manuals
Manual 20 pages 52.65 Kb
Top Page Image Contents