Pelco FR85011A manual Installation, Package Contents, Data Communication Setup

Installation

PACKAGE CONTENTS

The following items are supplied:

1FT85011A transmitter or FR85011A receiver

1Regulated switching power supply with four plug adapters (North American, Australian, U.K., and European configurations); 100-240 VAC, 50-60 Hz input, 12 VDC output

1Wall clip with two 4-40 x 0.250-inch Phillips pan head screws with lock washers (for attach- ment of single module to wall)

1 FT85011A/FR85011A Fiber Transmitter and Receiver Installation manual (this manual)

DATA COMMUNICATION SETUP

NOTE: As a matter of convenience, it is recommended that you set the desired data communication before mounting the FT85011A transmitter/FR85011A receiver into a rack or onto a wall.

The Data Selection switch, which is located on the rear panel of the FT85011A transmitter/FR85011A receiver, is a 10-position rotary switch that allows you to set the data communication required for the transfer of data (refer to Figure 4).

1

2

3

4

5

6

7

8 GND

1 2		3	4
0			5
9	8	7	6

1	2	3	4	DATA
0			5
				SELECTION
9 8		7	6	SWITCH

Figure 4. Data Selection Switch

12 C2604M (7/06)