Pelco C2624M manual Installation, Package Contents

Page 12

Installation

PACKAGE CONTENTS

The following items are supplied:

1FX82012 module

1Regulated switching power supply with four plug adapters (North American, Australian, U.K., and European configurations); 100-240 VAC, 50-60 Hz input, 12 VDC output

1Wall clip with two 4-40 x 0.250-inch Phillips pan head screws with lock washers (for attachment of single module to wall)

1FX82012 Unmanaged Ethernet Switch Installation manual (this manual)

SETTING 10BASE-T/100BASE-TX PORT MODES OF OPERATION

NOTE: As a matter of convenience, it is recommended that you verify the modes of operation for the 10BASE-T/100BASE-TX port and then change the mode settings—if necessary—before mounting the FX82012 module into a rack or onto a wall.

The FX82012 module provides various configuration options that allow you to select the desired modes of operation for the 10BASE-T/100BASE-TX port. You can select the desired modes of operation by means of a TX Mode switch that is provided on the bottom of the module (refer to Figure 5).

TX Mode

0.Auto Neg / Dis FC

1.100 FD / Dis FC

2. 100 HD / Dis FC

3.10 FD / Dis FC

4.10 HD / Dis FC

5.Auto Neg / En FC

6.100 FD / En FC

7.100 HD / En FC

8.10 FD / En FC

9.10 HD / En FC

FX Mode

0. Independent A & B

1. Auto Failover

A is Primary

2. Auto Failover

B is Primary

3-9 NOT USED

TX MODE SWITCH

Figure 5. TX Mode Switch for 10BASE-T/100BASE-TX Port

12

C2624M (6/07)

Image 12
Contents Ethernet Switch Contents List of IllustrationsFX Mode Switch Settings RJ-45MDI/MDI-X Connector PinoutsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Regulatory Notices Radio and Television InterferenceProduct Overview DescriptionC2624M 6/07 Models FX82012 module consists of the following series of modelsMultimode Models Single-Mode Models*†Front Panel Illustrates the front panel of the FX82012 moduleRear Panel Illustrates the rear panel of the FX82012 moduleInstallation Package ContentsAutonegotiation is enabled by default Flow control is disabled by defaultFlow control default setting 10BASE-T/100BASE-TX Modes of OperationSetting Fiber Failover Mode FX Mode SwitchMode of Operation MountingMounting the FX82012 Module to a Wall PAN Head with Wall Clip Lock Washer Connections Fiber connections Primary Fiber Port Connections in Sample Drop-and-Repeat Application Troubleshooting Module Reseat module or power Supply as necessaryReplace power supply Meaning Indication Fefi On local module Optical signal Optic Fault LED on local Section in this tableReplace local module By the remote linkMeaning Possible Cause Corrective Action Optic Fault LED Table D. Troubleshooting with Rear-Panel Indicators AmberIf 10BASE-T operation is EstablishedMeaning Possible Cause Corrective Action Duplex mode Link Refer to the SettingIf half-duplex mode is Amber Port is set toGreen Port is set to If 100BASE-TX full-duplex Full-duplex operation is notFlashing green Port is set to Tion or by manuallyTable D. Troubleshooting with Rear-Panel Indicators Specifications Power Wavelength Optical MaximumBudget Multimode 62.5/125 μmAppendix. RJ-45 Connector Pinouts Illustrates RJ-45 MDI/MDI-X connector pinoutsC2624M 6/07 Product Warranty and Return Information ISO9001