Pelco manual C2624M 6/07

Features of the FX82012 Ethernet switch include the following:

•User-selectable 10BASE-T/100BASE-TX networking functions:

–Autonegotiation between 10 Mbps and 100 Mbps data rates and between full-duplex and half-duplex modes

–10 Mbps or 100 Mbps selectable

–Full-duplex or half-duplex mode selectable

–Enabling/disabling of flow control

NOTE: The 100BASE-FX fiber ports are automatically forced to full-duplex 100 Mbps operation.

•Auto MDI/MDI-X (Medium Dependent Interface/Medium Dependent Interface Crossover) operation

•Compliant with IEEE 802.3, 802.3u, and 802.3x standards

•Multimode fiber support for distances up to 2 km

•Single-mode fiber support for distances up to 46 km

•Compatible with other Ethernet equipment:

–10BASE-T/100BASE-TX compatibility with all Pelco® and third-party 10BASE-T/ 100BASE-TX Ethernet devices

–Fiber optic compatibility with all Pelco Ethernet devices that support WDM

•Laser diode for transmission of optical signals

NOTE: The FX82012 switch is a Class 1 laser product that complies with FDA radiation performance standard 21CFR Subchapter J and with IEC 60825-1 Edition 1.2, 2001-08.

•Environmentally hardened

•Designed to meet NEMA TS 2 and Caltrans traffic signal control equipment standards for ambient operating temperature, mechanical shock and vibration, humidity with condensation, high-line/low-line voltage conditions, and transient voltage protection

NOTE: Conformal coating is required for operation in environments with relative humidity above 95 percent (condensing).

•No performance adjustments required

•12 VDC or 24 VAC power supply

•Stand-alone and rack-mountable modular design

•LED indicators for monitoring of fiber redundancy mode status, optic signal/laser status, 100BASE-FX port status including far end fault indication (FEFI), 10BASE-T/100BASE-TX port status, and operating power

8 C2624M (6/07)